TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AM625: MMC0 PCB Connectivity Requirements

    reto hermann
    reto hermann
    Part Number: AM625 Tool/software: Hi we have issues with an eMMC connected to MMC0 of a AM6254 processor on a custom board. In the datasheet of the AM625 processors we found layout requirements for the MMC0 interface. Does this "min" specification…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] PROCESSOR-SDK-AM64X: How to enable RTOS based PCIE-PTM

    Ashwani Goel
    Ashwani Goel
    Part Number: PROCESSOR-SDK-AM64X Other Parts Discussed in Thread: TMDS243EVM Tool/software: Hi TI Expert, How can we use AM64x/ AM243x - MCU+SDK to enable PCIE based Precision Time Measurement (PTM) ? Regards
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] How do I build the native IgH EtherCAT stack for TI microprocessors?

    Jared McArthur
    Jared McArthur
    Part Number: AM62 Tool/software: The IgH EtherCAT stack is an open source EtherCAT stack. It comes with a generic driver that uses generic Linux ethernet API calls, but is not optimized for specific platforms, and therefore comes with latency. …
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM: How to run ETHFW without connecting GESI card to J721EXCPXEVM for TDA4VM/J721E?

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM Other Parts Discussed in Thread: J721EXCPXEVM , Tool/software: How to run ETHFW without connecting GESI card to J721EXCPXEVM for TDA4VM/J721E? When using TI SDK ETHFW was failed to load.
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM620-Q1: Connect SRAM to GPMC

    FM
    FM
    Part Number: AM620-Q1 Tool/software: Hi TI Team, I would like to avoid LPDDR4 memory because of cost. Is it possible to connect a standard 16-bit SRAM to the GPMC? Can you recommend any p/n? What is the maximum addressing size? Voltage…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM6421: How many reflow is acceptable at new package ANI?

    Tsurumoto
    Tsurumoto
    Part Number: AM6421 Tool/software: Hi To decide if customer use AM6421 for their new product or not, they need the information about how many reflow is acceptable at new package ANI. What's the limit number of reflow of AM6421BSEFHIANIR?
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] TLV62585: Input voltage vs Output voltage - AM64x AM62x Discrete power architecture

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: TLV62585 Tool/software: Hi Experts, I am reviewing a customer schematic. Customer is using TLV62585DRLR the input is 4.2V and could be switched to 3V. The output is 3.3V. Do you have any concern with the TLV62585DRLR providing…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] How to flash and boot Linux from NAND with AM335x Linux SDK 9.1

    Hong Guan64
    Hong Guan64
    Part Number: AM3358 Tool/software: AM335x GPMC-NAND boot issue was observed with AM335x Linux SDK 9.1 [1]. The FAQ lists the u-boot and kernel patches to support flashing and booting u-boot/kernel/root_fs with AM335x Linux SDK 9.1 from GPMC-NAND on…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] : Reset Module on AM64X / AM243/AM62X SOC's

    Swargam Anil
    Swargam Anil
    Part Number: AM6442 Tool/software: In AM64X/AM243/AM62X there are many Resets. So, what is the difference between each type of Reset? What is the boot flow for each Reset ? What are the Registers/Peripherals affected for each Reset ? How different…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] J784S4XEVM: How to create EXT4 rootfs on UFS and boot to Linux using UFS

    Keerthy J
    Keerthy J
    Part Number: J784S4XEVM Tool/software: UFS is present on the J784S4EVM. How can one use it instead of eMMC to host rootfs and use that to boot to Linux command prompt.
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198583 Discussions
  • Not Answered

    combine all 1.8V signal pin to ONE power source? 0 Locked

    124 views
    1 reply
    Latest over 11 years ago
    by Biser Gatchev-XID
  • Not Answered

    compass HMC58XX support in OMAP-L138 0 Locked

    1779 views
    9 replies
    Latest over 11 years ago
    by Titusrathinaraj Stalin
  • Answered

    Low cost solution for Image processing for Facial Recogination through Camera 0 Locked

    506 views
    5 replies
    Latest over 11 years ago
    by arron lee
  • Not Answered

    Redirect faulty microphone 0 Locked

    564 views
    3 replies
    Latest over 11 years ago
    by Vojtech Kral
  • Answered

    [SOLVED] How to write first driver in WinCE that shoulbd be the subproject of BSP? 0 Locked

    759 views
    5 replies
    Latest over 11 years ago
    by Seetharam Nayak
  • Not Answered

    Can GV7601's YUV 10bit Output be connected to DM8168 8Bit Port DIRECTLY to transfer 1080P30 video data? 0 Locked

    1619 views
    3 replies
    Latest over 11 years ago
    by Brijesh Jadav
  • Not Answered

    OMAP L138 LCDK 0 Locked

    838 views
    6 replies
    Latest over 11 years ago
    by Yanko Todorov-XID
  • Not Answered

    How To Config to use DM8168 HDCOMP(VGA) 0 Locked

    463 views
    3 replies
    Latest over 11 years ago
    by Brijesh Jadav
  • Not Answered

    TI chip does support BT.1120 embedded TRS timing ? 0 Locked

    1904 views
    8 replies
    Latest over 11 years ago
    by Brijesh Jadav
  • Not Answered

    How to use AM3358 as a Ethercat slave 0 Locked

    192 views
    1 reply
    Latest over 11 years ago
    by PratheeshGangadhar
  • Not Answered

    Ethercat application 0 Locked

    635 views
    6 replies
    Latest over 11 years ago
    by Bindu Ganesh
  • Not Answered

    gel file for omap4430_ccsv4 0 Locked

    251 views
    1 reply
    Latest over 11 years ago
    by Yordan Kovachev
  • Not Answered

    AM335x beaglebone black frame buffer open fail when add NFC 0 Locked

    1078 views
    0 replies
    Started over 11 years ago
    by Lucas Lu1
  • Answered

    C5000 Connected Audio Framework CAF 2.00.02.04 build and Playback/USB enumeration problem 0 Locked

    569 views
    1 reply
    Latest over 11 years ago
    by Gunter Schmer
  • Answered

    repo sync pull only OMAP5 relevant code/branches 0 Locked

    406 views
    1 reply
    Latest over 11 years ago
    by Boyko Kazakov
  • Not Answered

    AM3715 linux oops issue 0 Locked

    2857 views
    6 replies
    Latest over 11 years ago
    by Gary Wu
  • Answered

    I set slice nunber = 5 but get 264 file with slice = 3 0 Locked

    429 views
    3 replies
    Latest over 11 years ago
    by Sudheesh
  • Answered

    Does SYSBIOS support NAND flash file system or RTFS? 0 Locked

    1186 views
    2 replies
    Latest over 11 years ago
    by Ning Sun
  • Answered

    What kind of USB DMA protocol should I use with Isochronous on C5535? 0 Locked

    371 views
    2 replies
    Latest over 11 years ago
    by j-breeze
  • Answered

    1080p25 H.264 HP encoding on 4 cores on C66x DSP 0 Locked

    778 views
    3 replies
    Latest over 11 years ago
    by Ramamohana Reddy
<>