TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AM625: MMC0 PCB Connectivity Requirements

    reto hermann
    reto hermann
    Part Number: AM625 Tool/software: Hi we have issues with an eMMC connected to MMC0 of a AM6254 processor on a custom board. In the datasheet of the AM625 processors we found layout requirements for the MMC0 interface. Does this "min" specification…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] PROCESSOR-SDK-AM64X: How to enable RTOS based PCIE-PTM

    Ashwani Goel
    Ashwani Goel
    Part Number: PROCESSOR-SDK-AM64X Other Parts Discussed in Thread: TMDS243EVM Tool/software: Hi TI Expert, How can we use AM64x/ AM243x - MCU+SDK to enable PCIE based Precision Time Measurement (PTM) ? Regards
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] How do I build the native IgH EtherCAT stack for TI microprocessors?

    Jared McArthur
    Jared McArthur
    Part Number: AM62 Tool/software: The IgH EtherCAT stack is an open source EtherCAT stack. It comes with a generic driver that uses generic Linux ethernet API calls, but is not optimized for specific platforms, and therefore comes with latency. …
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM: How to run ETHFW without connecting GESI card to J721EXCPXEVM for TDA4VM/J721E?

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM Other Parts Discussed in Thread: J721EXCPXEVM , Tool/software: How to run ETHFW without connecting GESI card to J721EXCPXEVM for TDA4VM/J721E? When using TI SDK ETHFW was failed to load.
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM620-Q1: Connect SRAM to GPMC

    FM
    FM
    Part Number: AM620-Q1 Tool/software: Hi TI Team, I would like to avoid LPDDR4 memory because of cost. Is it possible to connect a standard 16-bit SRAM to the GPMC? Can you recommend any p/n? What is the maximum addressing size? Voltage…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM6421: How many reflow is acceptable at new package ANI?

    Tsurumoto
    Tsurumoto
    Part Number: AM6421 Tool/software: Hi To decide if customer use AM6421 for their new product or not, they need the information about how many reflow is acceptable at new package ANI. What's the limit number of reflow of AM6421BSEFHIANIR?
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] TLV62585: Input voltage vs Output voltage - AM64x AM62x Discrete power architecture

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: TLV62585 Tool/software: Hi Experts, I am reviewing a customer schematic. Customer is using TLV62585DRLR the input is 4.2V and could be switched to 3V. The output is 3.3V. Do you have any concern with the TLV62585DRLR providing…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] How to flash and boot Linux from NAND with AM335x Linux SDK 9.1

    Hong Guan64
    Hong Guan64
    Part Number: AM3358 Tool/software: AM335x GPMC-NAND boot issue was observed with AM335x Linux SDK 9.1 [1]. The FAQ lists the u-boot and kernel patches to support flashing and booting u-boot/kernel/root_fs with AM335x Linux SDK 9.1 from GPMC-NAND on…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] : Reset Module on AM64X / AM243/AM62X SOC's

    Swargam Anil
    Swargam Anil
    Part Number: AM6442 Tool/software: In AM64X/AM243/AM62X there are many Resets. So, what is the difference between each type of Reset? What is the boot flow for each Reset ? What are the Registers/Peripherals affected for each Reset ? How different…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] J784S4XEVM: How to create EXT4 rootfs on UFS and boot to Linux using UFS

    Keerthy J
    Keerthy J
    Part Number: J784S4XEVM Tool/software: UFS is present on the J784S4EVM. How can one use it instead of eMMC to host rootfs and use that to boot to Linux command prompt.
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198127 Discussions
  • Not Answered

    Does OMAP 4460 support virtualization ? 0 Locked

    278 views
    0 replies
    Started over 12 years ago
    by Resmi
  • Answered

    Request for TI's kernel and application software such as omapfbplay(or any player) such that it uses h/w accelerator in OMAP4460 to play video files ? 0 Locked

    1518 views
    8 replies
    Latest over 12 years ago
    by Resmi
  • Not Answered

    Color incorrect when capture TMS320DM36x EVM and LI-5M02 module 0 Locked

    167 views
    0 replies
    Started over 12 years ago
    by qin zhujun
  • Answered

    ALSA driver 0 Locked

    756 views
    5 replies
    Latest over 12 years ago
    by Clemens Ladisch
  • Not Answered

    how to program boot configuration table to EVM6678 0 Locked

    827 views
    1 reply
    Latest over 12 years ago
    by xiao weihua
  • Not Answered

    welcome expert, please enter see see, 6678 tftp boot failed. 0 Locked

    319 views
    0 replies
    Started over 12 years ago
    by xiao weihua
  • Not Answered

    How to call ARM application from DSP in OMAP L138 0 Locked

    329 views
    4 replies
    Latest over 12 years ago
    by Ashish Kumar Mishra
  • Not Answered

    C6657/5 SPI Boot Speed ( Can it operate faster ? ) 0 Locked

    1108 views
    5 replies
    Latest over 12 years ago
    by George Lathrop
  • Answered

    AM335x and TPS65217C getting shut down 0 Locked

    480 views
    2 replies
    Latest over 12 years ago
    by David Paden
  • Answered

    C66x SRIO DIO TX/RX buffers size 0 Locked

    273 views
    2 replies
    Latest over 12 years ago
    by HRi
  • Suggested Answer

    CCS5 and CSL2.5 and CSL3 0 Locked

    463 views
    4 replies
    Latest over 12 years ago
    by Juliana Mansell
  • Not Answered

    Monolithic descriptor onto PA 0 Locked

    352 views
    1 reply
    Latest over 12 years ago
    by RCReddy
  • Answered

    6657 edma spi 0 Locked

    461 views
    3 replies
    Latest over 12 years ago
    by Elush Shirazpour
  • Not Answered

    TMS320C6678 REV-2.0 0 Locked

    190 views
    2 replies
    Latest over 12 years ago
    by RandyP
  • Answered

    Cannot get the restore factory default images instructions to run 0 Locked

    307 views
    2 replies
    Latest over 12 years ago
    by David Newman3
  • Answered

    Trouble with 6678 EVM configuration 0 Locked

    638 views
    3 replies
    Latest over 12 years ago
    by David Newman3
  • Not Answered

    Compiling for C67XX for OMAPL138 0 Locked

    381 views
    6 replies
    Latest over 12 years ago
    by Don Masin
  • Not Answered

    How to do Uint16 & Floats in DSPLINK/ReadWrite example, WinCE6.0 0 Locked

    250 views
    0 replies
    Started over 12 years ago
    by Don Masin
  • Not Answered

    Mount File System Failed 0 Locked

    346 views
    2 replies
    Latest over 12 years ago
    by Pavel Botev
  • Answered

    Can't register vpss and hdmi driver when using EZSDK5_05_01_04 on DM8168EVM 0 Locked

    3255 views
    30 replies
    Latest over 12 years ago
    by echo yang
<>