TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AM625: MMC0 PCB Connectivity Requirements

    reto hermann
    reto hermann
    Part Number: AM625 Tool/software: Hi we have issues with an eMMC connected to MMC0 of a AM6254 processor on a custom board. In the datasheet of the AM625 processors we found layout requirements for the MMC0 interface. Does this "min" specification…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] PROCESSOR-SDK-AM64X: How to enable RTOS based PCIE-PTM

    Ashwani Goel
    Ashwani Goel
    Part Number: PROCESSOR-SDK-AM64X Other Parts Discussed in Thread: TMDS243EVM Tool/software: Hi TI Expert, How can we use AM64x/ AM243x - MCU+SDK to enable PCIE based Precision Time Measurement (PTM) ? Regards
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] How do I build the native IgH EtherCAT stack for TI microprocessors?

    Jared McArthur
    Jared McArthur
    Part Number: AM62 Tool/software: The IgH EtherCAT stack is an open source EtherCAT stack. It comes with a generic driver that uses generic Linux ethernet API calls, but is not optimized for specific platforms, and therefore comes with latency. …
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM: How to run ETHFW without connecting GESI card to J721EXCPXEVM for TDA4VM/J721E?

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM Other Parts Discussed in Thread: J721EXCPXEVM , Tool/software: How to run ETHFW without connecting GESI card to J721EXCPXEVM for TDA4VM/J721E? When using TI SDK ETHFW was failed to load.
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM620-Q1: Connect SRAM to GPMC

    FM
    FM
    Part Number: AM620-Q1 Tool/software: Hi TI Team, I would like to avoid LPDDR4 memory because of cost. Is it possible to connect a standard 16-bit SRAM to the GPMC? Can you recommend any p/n? What is the maximum addressing size? Voltage…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM6421: How many reflow is acceptable at new package ANI?

    Tsurumoto
    Tsurumoto
    Part Number: AM6421 Tool/software: Hi To decide if customer use AM6421 for their new product or not, they need the information about how many reflow is acceptable at new package ANI. What's the limit number of reflow of AM6421BSEFHIANIR?
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] TLV62585: Input voltage vs Output voltage - AM64x AM62x Discrete power architecture

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: TLV62585 Tool/software: Hi Experts, I am reviewing a customer schematic. Customer is using TLV62585DRLR the input is 4.2V and could be switched to 3V. The output is 3.3V. Do you have any concern with the TLV62585DRLR providing…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] How to flash and boot Linux from NAND with AM335x Linux SDK 9.1

    Hong Guan64
    Hong Guan64
    Part Number: AM3358 Tool/software: AM335x GPMC-NAND boot issue was observed with AM335x Linux SDK 9.1 [1]. The FAQ lists the u-boot and kernel patches to support flashing and booting u-boot/kernel/root_fs with AM335x Linux SDK 9.1 from GPMC-NAND on…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] : Reset Module on AM64X / AM243/AM62X SOC's

    Swargam Anil
    Swargam Anil
    Part Number: AM6442 Tool/software: In AM64X/AM243/AM62X there are many Resets. So, what is the difference between each type of Reset? What is the boot flow for each Reset ? What are the Registers/Peripherals affected for each Reset ? How different…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] J784S4XEVM: How to create EXT4 rootfs on UFS and boot to Linux using UFS

    Keerthy J
    Keerthy J
    Part Number: J784S4XEVM Tool/software: UFS is present on the J784S4EVM. How can one use it instead of eMMC to host rootfs and use that to boot to Linux command prompt.
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198111 Discussions
  • Not Answered

    Need_info_explanation 0 Locked

    104 views
    0 replies
    Started over 13 years ago
    by Hot snow
  • Answered

    "Skew Length Mismatch" in OMAP-L138 Datasheet 0 Locked

    859 views
    3 replies
    Latest over 13 years ago
    by Hot snow
  • Answered

    DSP library function - DSP_maxidx() 0 Locked

    536 views
    6 replies
    Latest over 13 years ago
    by nemis
  • Not Answered

    ABOUT CODEC SERVER 0 Locked

    102 views
    0 replies
    Started over 13 years ago
    by ZHOUFA
  • Answered

    Can't enable RTA 0 Locked

    3332 views
    27 replies
    Latest over 13 years ago
    by judahvang
  • Not Answered

    Access S29NS Spansion NOR from x-loader in DM3730. 0 Locked

    1115 views
    13 replies
    Latest over 13 years ago
    by Javier Martin19423
  • Answered

    dm6467T EVM: Understanding VPIF - raw mode 0 Locked

    2168 views
    15 replies
    Latest over 13 years ago
    by jim xu
  • Discussion

    UPP Receive Locked

    321 views
    3 replies
    Latest over 13 years ago
    by Raghavendra Maddikery
  • Not Answered

    Where can I insert some effects algorithm into the record and/or playback path? 0 Locked

    155 views
    0 replies
    Started over 13 years ago
    by alex dodo
  • Answered

    Hwi ISR can only be entered once 0 Locked

    739 views
    1 reply
    Latest over 13 years ago
    by judahvang
  • Not Answered

    DM368 interlace artifact 0 Locked

    292 views
    1 reply
    Latest over 13 years ago
    by Mike Whittaker
  • Answered

    Dual stream(H264 +MJPEG) alignement trap if width more than 2048 0 Locked

    1945 views
    15 replies
    Latest over 13 years ago
    by Veeranna Hanchinal
  • Answered

    Problem with EDMA3 event queues and McBsp0 on C6457 0 Locked

    362 views
    2 replies
    Latest over 13 years ago
    by Roberto Scimia
  • Answered

    DM648: how to configure the DDR2 512MB 0 Locked

    376 views
    6 replies
    Latest over 13 years ago
    by keanu Feng
  • Answered

    PCIe Boot of C6678 and platform_init 0 Locked

    1134 views
    7 replies
    Latest over 13 years ago
    by Phil Dawson
  • Not Answered

    DMAI: Fifo_get() does not see buffers from Fifo_put() when in separate thread 0 Locked

    453 views
    0 replies
    Started over 13 years ago
    by Mike Whittaker
  • Discussion

    Missing closing bracket in emifa.h Locked

    238 views
    3 replies
    Latest over 13 years ago
    by David Luca
  • Not Answered

    How to know wakeup cause after a sleep/standby mode? 0 Locked

    165 views
    0 replies
    Started over 13 years ago
    by Pierre Savary
  • Not Answered

    Onvif with DM368 V3 0 Locked

    526 views
    1 reply
    Latest over 13 years ago
    by Barath Silvanlabs
  • Not Answered

    how to use dsplink api in IDE(vs2005) 0 Locked

    163 views
    0 replies
    Started over 13 years ago
    by sum liu
<>