TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DRA821: SPL BOOT without A72 SPL on J7200 on 10.1 SDK

    Gokul Praveen
    Gokul Praveen
    Part Number: DRA821 Tool/software: How to enable Falcon Boot Mode on J7200? Boot Flow: R5 SPL -> ATF -> OPTEE -> U-BOOT -> Kernel Regards Gokul
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to avoid crashing the DM R5F when writing custom DM R5F firmware

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, on some devices (not all devices!), TI supports writing custom code to run on the DM R5F, alongside the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] SBL boot: How to find the DM R5F firmware that is loaded by SBL

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the DM R5F, alongside the DM task. The firmware running on the…
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4AL-Q1: Large byte transfer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4AL-Q1 Tool/software: Example application on SDK 10.0 to show large byte transfer between CDD IPC(MCU1_0) and Linux (A72) using cdd_ipc_rc_linux ,rpsmg_char_simple applications on J721S2 ?
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to check if Linux can communicate with a non-Linux core through RPMsg

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Before Linux can communicate with a non-Linux core over the RPMsg inter-processor communication (IPC) protocol, several things needs to be true: 1) RPMsg between Linux and the non-Linux core must be supported…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Linux: How to check what binary is running on the DM R5F

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px, AM67, AM67A The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM-Q1: How to enable cross domain UART access from PDK applications.

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM-Q1 Tool/software: On custom boards where UART instances are limited, how can I route debug output from my application running in one domain to a UART instance available in different domain? Specially, I want to enable cross-domain…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] EDGE-AI-STUDIO: TIDL RTOS tool vs edgeai-tidl-tools

    Adam Hua
    Adam Hua
    Part Number: EDGE-AI-STUDIO Tool/software: Model importing in TI has two sets of tools due to historical reasons. These two sets has developed in parallel for a long time. Here is an explanation of the similarity and difference of the two tools. …
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] What is Active Slot bitmask, Data Bitmask, and Transaction Count in MCASP?

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM62D-EVM AUDIO-AM275-EVM Other Parts Discussed in Thread: SYSCONFIG Tool/software: 1. While configuring McASP through sysConfig, I found that when the num of slots set as 2, the active slot bitmask can only below 3. What is this…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Not able to return from infinity loop in C7 core by changing the loop variable using CCS

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM275-EVM Tool/software: I am not able to return from infinity loop in C7x core by changing the loop variable from the Variables tab in CCS. In the following code - void loop_forever() { volatile uint32_t loop = 1U; while(loop…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 197748 Discussions
  • Answered

    Problems with Building Lesson 5 of RTSC Tutorial 0 Locked

    957 views
    8 replies
    Latest over 14 years ago
    by dave russo
  • Not Answered

    uController or DSP with USB High Speed interface 0 Locked

    121 views
    0 replies
    Started over 14 years ago
    by Alessandro Giovannini
  • Not Answered

    Problem with MACSTATUS.idle bit 0 Locked

    154 views
    0 replies
    Started over 14 years ago
    by sergey manuhin
  • Answered

    TMS320TCI6486 - Online Training 0 Locked

    300 views
    3 replies
    Latest over 14 years ago
    by Venkat Kumar
  • Not Answered

    Regarding OMAP 3730 0 Locked

    161 views
    0 replies
    Started over 14 years ago
    by pushpa v g
  • Not Answered

    Run DavinciGPIOExample on DM355 board 0 Locked

    154 views
    0 replies
    Started over 14 years ago
    by Mayank Agarwal
  • Not Answered

    getting started with ccsv4 0 Locked

    110 views
    0 replies
    Started over 14 years ago
    by pushpa v g
  • Not Answered

    How do I access EMIF between ADC and OMAP-L137/C6747 ? 0 Locked

    417 views
    4 replies
    Latest over 14 years ago
    by Yang HsiYuan
  • Not Answered

    TMS320C6A8168: eSATA support 0 Locked

    307 views
    0 replies
    Started over 14 years ago
    by Mahesh Shinde
  • Not Answered

    OMAP35xx MPEG4 Encoder Parameter in VOL Header 0 Locked

    135 views
    0 replies
    Started over 14 years ago
    by j-breeze
  • Not Answered

    drivers for Mt9v031 0 Locked

    714 views
    1 reply
    Latest over 14 years ago
    by Nilesh Mane
  • Answered

    DSP link configuration 0 Locked

    341 views
    3 replies
    Latest over 14 years ago
    by Wang Song77575
  • Not Answered

    A problem about spi operation of DM6467 0 Locked

    309 views
    0 replies
    Started over 14 years ago
    by aa aa1
  • Suggested Answer

    c6747 usb cppi dma teardown 0 Locked

    556 views
    6 replies
    Latest over 14 years ago
    by Kiung Chung Wong
  • Not Answered

    usb streamer support for linux 0 Locked

    261 views
    1 reply
    Latest over 14 years ago
    by Ajay
  • Answered

    Video frame shifting when source plugged in again on DN6467T 0 Locked

    379 views
    3 replies
    Latest over 14 years ago
    by caijun qin
  • Not Answered

    basic question about port disable/enable 0 Locked

    239 views
    2 replies
    Latest over 14 years ago
    by digital qtum
  • Not Answered

    unable to capture BT1120 over vpif 0 Locked

    1080 views
    13 replies
    Latest over 14 years ago
    by Sergei Kruglov
  • Not Answered

    Beagleboard-xM Revision C. Need to enable USB Hub 0 Locked

    444 views
    2 replies
    Latest over 14 years ago
    by Ajay
  • Answered

    C6747/6745 PLLOUT Spec 0 Locked

    238 views
    2 replies
    Latest over 14 years ago
    by j-breeze
<>