TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DRA821: SPL BOOT without A72 SPL on J7200 on 10.1 SDK

    Gokul Praveen
    Gokul Praveen
    Part Number: DRA821 Tool/software: How to enable Falcon Boot Mode on J7200? Boot Flow: R5 SPL -> ATF -> OPTEE -> U-BOOT -> Kernel Regards Gokul
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to avoid crashing the DM R5F when writing custom DM R5F firmware

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, on some devices (not all devices!), TI supports writing custom code to run on the DM R5F, alongside the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] SBL boot: How to find the DM R5F firmware that is loaded by SBL

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the DM R5F, alongside the DM task. The firmware running on the…
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4AL-Q1: Large byte transfer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4AL-Q1 Tool/software: Example application on SDK 10.0 to show large byte transfer between CDD IPC(MCU1_0) and Linux (A72) using cdd_ipc_rc_linux ,rpsmg_char_simple applications on J721S2 ?
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to check if Linux can communicate with a non-Linux core through RPMsg

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Before Linux can communicate with a non-Linux core over the RPMsg inter-processor communication (IPC) protocol, several things needs to be true: 1) RPMsg between Linux and the non-Linux core must be supported…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Linux: How to check what binary is running on the DM R5F

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px, AM67, AM67A The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM-Q1: How to enable cross domain UART access from PDK applications.

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM-Q1 Tool/software: On custom boards where UART instances are limited, how can I route debug output from my application running in one domain to a UART instance available in different domain? Specially, I want to enable cross-domain…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] EDGE-AI-STUDIO: TIDL RTOS tool vs edgeai-tidl-tools

    Adam Hua
    Adam Hua
    Part Number: EDGE-AI-STUDIO Tool/software: Model importing in TI has two sets of tools due to historical reasons. These two sets has developed in parallel for a long time. Here is an explanation of the similarity and difference of the two tools. …
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] What is Active Slot bitmask, Data Bitmask, and Transaction Count in MCASP?

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM62D-EVM AUDIO-AM275-EVM Other Parts Discussed in Thread: SYSCONFIG Tool/software: 1. While configuring McASP through sysConfig, I found that when the num of slots set as 2, the active slot bitmask can only below 3. What is this…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Not able to return from infinity loop in C7 core by changing the loop variable using CCS

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM275-EVM Tool/software: I am not able to return from infinity loop in C7x core by changing the loop variable from the Variables tab in CCS. In the following code - void loop_forever() { volatile uint32_t loop = 1U; while(loop…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 197749 Discussions
  • Suggested Answer

    Failure by building OMAP35x Graphic SDK Demos on AM3517 EVM 0 Locked

    1105 views
    12 replies
    Latest over 15 years ago
    by José
  • Not Answered

    OMAP3 EVM board, Ethernet MAC and Flash Partitions / NAND support 0 Locked

    503 views
    6 replies
    Latest over 15 years ago
    by Arno Steffens
  • Not Answered

    audio noise 0 Locked

    339 views
    2 replies
    Latest over 15 years ago
    by Rain Peng
  • Not Answered

    I would like some help getting the PCM2912A USB Audio chip working with a Linux based system 0 Locked

    304 views
    0 replies
    Started over 15 years ago
    by 99guspuppet
  • Answered

    Can I make the BIOSUSB's example run without JTAG? 0 Locked

    401 views
    2 replies
    Latest over 15 years ago
    by Haoxing Li
  • Not Answered

    UART implementation using McBSP and EDMA 0 Locked

    615 views
    2 replies
    Latest over 15 years ago
    by tlee
  • Not Answered

    OMAP-L137, McASP, TDM, I2S 0 Locked

    686 views
    7 replies
    Latest over 15 years ago
    by tlee
  • Not Answered

    Clocks for echo cancellation 0 Locked

    310 views
    1 reply
    Latest over 15 years ago
    by Miguel A. Alanis
  • Answered

    Packet Timestamps etc in NDK 2.0 0 Locked

    745 views
    1 reply
    Latest over 15 years ago
    by Marian Stagarescu
  • Not Answered

    Setting aic3204 registers using the CSL... 0 Locked

    674 views
    2 replies
    Latest over 15 years ago
    by Andrea Zanelli
  • Answered

    5509A Boot Table Byte Order 0 Locked

    385 views
    1 reply
    Latest over 15 years ago
    by Brad Griffis
  • Not Answered

    DM365 UBL sets AEMIF EM_CE0 to GPIO. Why? 0 Locked

    354 views
    2 replies
    Latest over 15 years ago
    by Marco Braga
  • Discussion

    Office Hours for Getting Hands-On: Linux GDB debugger on TI's OMAP/DaVinci platforms Locked

    276 views
    4 replies
    Latest over 15 years ago
    by Bernie Thompson TI
  • Not Answered

    problem about dsplink example on omapl137 0 Locked

    204 views
    1 reply
    Latest over 15 years ago
    by Mariana
  • Answered

    New Installation...can't launch a new target configuration 0 Locked

    321 views
    2 replies
    Latest over 15 years ago
    by Robert Gray15490
  • Not Answered

    Change the frame rate with IPCAM DM355 0 Locked

    290 views
    5 replies
    Latest over 15 years ago
    by rblode
  • Not Answered

    DSS output question 0 Locked

    1736 views
    14 replies
    Latest over 15 years ago
    by Steve Clynes
  • Answered

    How to handle external hardware interrupt 6 on UHPI HAS pin of C6727B DSP? 0 Locked

    474 views
    4 replies
    Latest over 15 years ago
    by Chun Fan
  • Not Answered

    OMAP3530: underrun!!! (at least 30.640 ms long) ... WHY???? 0 Locked

    632 views
    4 replies
    Latest over 15 years ago
    by Ken Chard
  • Not Answered

    Audio and Video SIngle Server on DM6467 evm 0 Locked

    153 views
    0 replies
    Started over 15 years ago
    by Parshant Gupta
<>