TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] How to avoid crashing the DM R5F when writing custom DM R5F firmware

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, on some devices (not all devices!), TI supports writing custom code to run on the DM R5F, alongside the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] SBL boot: How to find the DM R5F firmware that is loaded by SBL

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the DM R5F, alongside the DM task. The firmware running on the…
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4AL-Q1: Large byte transfer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4AL-Q1 Tool/software: Example application on SDK 10.0 to show large byte transfer between CDD IPC(MCU1_0) and Linux (A72) using cdd_ipc_rc_linux ,rpsmg_char_simple applications on J721S2 ?
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to check if Linux can communicate with a non-Linux core through RPMsg

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Before Linux can communicate with a non-Linux core over the RPMsg inter-processor communication (IPC) protocol, several things needs to be true: 1) RPMsg between Linux and the non-Linux core must be supported…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Linux: How to check what binary is running on the DM R5F

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px, AM67, AM67A The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM-Q1: How to enable cross domain UART access from PDK applications.

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM-Q1 Tool/software: On custom boards where UART instances are limited, how can I route debug output from my application running in one domain to a UART instance available in different domain? Specially, I want to enable cross-domain…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] EDGE-AI-STUDIO: TIDL RTOS tool vs edgeai-tidl-tools

    Adam Hua
    Adam Hua
    Part Number: EDGE-AI-STUDIO Tool/software: Model importing in TI has two sets of tools due to historical reasons. These two sets has developed in parallel for a long time. Here is an explanation of the similarity and difference of the two tools. …
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] What is Active Slot bitmask, Data Bitmask, and Transaction Count in MCASP?

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM62D-EVM AUDIO-AM275-EVM Other Parts Discussed in Thread: SYSCONFIG Tool/software: 1. While configuring McASP through sysConfig, I found that when the num of slots set as 2, the active slot bitmask can only below 3. What is this…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] Not able to return from infinity loop in C7 core by changing the loop variable using CCS

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM275-EVM Tool/software: I am not able to return from infinity loop in C7x core by changing the loop variable from the Variables tab in CCS. In the following code - void loop_forever() { volatile uint32_t loop = 1U; while(loop…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM62L / AM64x/ AM243x (ALV) / AM62Ax / AM62D-Q1 / AM62Px Design Recommendations / Commonly Observed Errors during Custom board hardware design – SDIO (embedded) interface

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM625 Other Parts Discussed in Thread: SK-AM62B-P1 , SYSCONFIG , CC3300 Tool/software: Hi TI Experts, Can you provide any available design guidelines for interfacing embedded SDIO device(s) using MMC1/MMC2 interface signals
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198173 Discussions
  • Not Answered

    Problem with memory map. 0 Locked

    269 views
    0 replies
    Started over 16 years ago
    by Marcin Pockaj
  • Not Answered

    OMAP L137 uart test code problems 0 Locked

    177 views
    0 replies
    Started over 16 years ago
    by John Cena
  • Answered

    OMAP-L137 UART problems 0 Locked

    624 views
    6 replies
    Latest over 16 years ago
    by John Cena
  • Not Answered

    Problem Having 2 video inputs (multiplexed) in a single video port (DM6446) using TVP5146 0 Locked

    212 views
    0 replies
    Started over 16 years ago
    by Ankit Shah
  • Not Answered

    loading binary through UART 0 Locked

    401 views
    7 replies
    Latest over 16 years ago
    by Roh@n T@bish
  • Not Answered

    How to compile my stub.c and skel.c in DM6446 platform. 0 Locked

    291 views
    0 replies
    Started over 16 years ago
    by mahesh kalmeshwar
  • Answered

    EVMOMAP-L137 audio streaming with uart control interface 0 Locked

    509 views
    6 replies
    Latest over 16 years ago
    by Diego10504
  • Not Answered

    Problem when using SPI at C6455 0 Locked

    552 views
    1 reply
    Latest over 16 years ago
    by RandyP
  • Not Answered

    Video capturing problem with DM642 0 Locked

    421 views
    2 replies
    Latest over 16 years ago
    by Leo Chen
  • Not Answered

    Motion Vector Access on DM6446 MPEG4 Encoder ? 0 Locked

    240 views
    0 replies
    Started over 16 years ago
    by John H
  • Not Answered

    DM365 Register Definitions 0 Locked

    274 views
    2 replies
    Latest over 16 years ago
    by Ken Koller
  • Answered

    DSP DMA on OMAP-L137 0 Locked

    2694 views
    21 replies
    Latest over 16 years ago
    by Gunjan
  • Not Answered

    HRDY behavior during multiplexed mode read operations on DM6437 0 Locked

    270 views
    0 replies
    Started over 16 years ago
    by Fabrizio
  • Not Answered

    Using dm355s audio codecs 0 Locked

    200 views
    0 replies
    Started over 16 years ago
    by Cristina Murillo
  • Answered

    dsplib,6727 0 Locked

    264 views
    3 replies
    Latest over 16 years ago
    by don morgan
  • Suggested Answer

    AIS utility for C6745/C6747 / memory test 0 Locked

    456 views
    3 replies
    Latest over 16 years ago
    by TimHarron
  • Suggested Answer

    Supply Voltage for TMS320VC5506 0 Locked

    408 views
    3 replies
    Latest over 16 years ago
    by Brad Griffis
  • Not Answered

    Integrating audio codecs on dm355 0 Locked

    211 views
    1 reply
    Latest over 16 years ago
    by Sid
  • Suggested Answer

    Generate Timer interrupts in dspbios without the PRD settings in the tcf-file 0 Locked

    581 views
    4 replies
    Latest over 16 years ago
    by Marcus_v70
  • Not Answered

    some questions about programme locate on memory and section 0 Locked

    315 views
    1 reply
    Latest over 16 years ago
    by RandyP
<>