TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DRA821: SPL BOOT without A72 SPL on J7200 on 10.1 SDK

    Gokul Praveen
    Gokul Praveen
    Part Number: DRA821 Tool/software: How to enable Falcon Boot Mode on J7200? Boot Flow: R5 SPL -> ATF -> OPTEE -> U-BOOT -> Kernel Regards Gokul
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to avoid crashing the DM R5F when writing custom DM R5F firmware

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, on some devices (not all devices!), TI supports writing custom code to run on the DM R5F, alongside the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] SBL boot: How to find the DM R5F firmware that is loaded by SBL

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the DM R5F, alongside the DM task. The firmware running on the…
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4AL-Q1: Large byte transfer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4AL-Q1 Tool/software: Example application on SDK 10.0 to show large byte transfer between CDD IPC(MCU1_0) and Linux (A72) using cdd_ipc_rc_linux ,rpsmg_char_simple applications on J721S2 ?
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to check if Linux can communicate with a non-Linux core through RPMsg

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Before Linux can communicate with a non-Linux core over the RPMsg inter-processor communication (IPC) protocol, several things needs to be true: 1) RPMsg between Linux and the non-Linux core must be supported…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Linux: How to check what binary is running on the DM R5F

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px, AM67, AM67A The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM-Q1: How to enable cross domain UART access from PDK applications.

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM-Q1 Tool/software: On custom boards where UART instances are limited, how can I route debug output from my application running in one domain to a UART instance available in different domain? Specially, I want to enable cross-domain…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] EDGE-AI-STUDIO: TIDL RTOS tool vs edgeai-tidl-tools

    Adam Hua
    Adam Hua
    Part Number: EDGE-AI-STUDIO Tool/software: Model importing in TI has two sets of tools due to historical reasons. These two sets has developed in parallel for a long time. Here is an explanation of the similarity and difference of the two tools. …
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] What is Active Slot bitmask, Data Bitmask, and Transaction Count in MCASP?

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM62D-EVM AUDIO-AM275-EVM Other Parts Discussed in Thread: SYSCONFIG Tool/software: 1. While configuring McASP through sysConfig, I found that when the num of slots set as 2, the active slot bitmask can only below 3. What is this…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Not able to return from infinity loop in C7 core by changing the loop variable using CCS

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM275-EVM Tool/software: I am not able to return from infinity loop in C7x core by changing the loop variable from the Variables tab in CCS. In the following code - void loop_forever() { volatile uint32_t loop = 1U; while(loop…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 197791 Discussions
  • Not Answered

    How can I get contiguous memory on DSP side under DM6446? 0 Locked

    476 views
    7 replies
    Latest over 16 years ago
    by Bernie Thompson TI
  • Not Answered

    Real Time Clock on DM355 0 Locked

    1036 views
    20 replies
    Latest over 16 years ago
    by ChiragShah
  • Not Answered

    McBSP in c6424 0 Locked

    316 views
    2 replies
    Latest over 16 years ago
    by baatezuu
  • Discussion

    Problem building kernel modules (where are the .ko files?) Locked

    1725 views
    7 replies
    Latest over 16 years ago
    by BrandonAzbell
  • Discussion

    CEapp-> ERROR: can't open engine video_copy Locked

    370 views
    1 reply
    Latest over 16 years ago
    by Juan Gonzales
  • Discussion

    When will the Linux BSP be available for the OMAP-L137? Locked

    343 views
    1 reply
    Latest over 16 years ago
    by Juan Gonzales
  • Discussion

    why not to put the flash image in the dm355_evm by NFS Locked

    358 views
    1 reply
    Latest over 16 years ago
    by Juan Gonzales
  • Discussion

    Problem finding header files Locked

    230 views
    2 replies
    Latest over 16 years ago
    by Juan Gonzales
  • Discussion

    How to apply for memory in a codec which run on dsp side? Locked

    253 views
    1 reply
    Latest over 16 years ago
    by Chris Ring
  • Discussion

    A problem about codec creation , I am using DM6446 Locked

    237 views
    2 replies
    Latest over 16 years ago
    by Bob5240
  • Discussion

    How can I use DVTB? Locked

    357 views
    2 replies
    Latest over 16 years ago
    by PremkumarJayakumar
  • Discussion

    use NFS to populate the YAFFS2 image Locked

    475 views
    1 reply
    Latest over 16 years ago
    by Juan Gonzales
  • Discussion

    DM355 reading Locked

    217 views
    1 reply
    Latest over 16 years ago
    by Juan Gonzales
  • Discussion

    Explanation of Video Interface Locked

    259 views
    2 replies
    Latest over 16 years ago
    by NeeravPatel
  • Not Answered

    Writing a simple program in DM355 EVM 0 Locked

    509 views
    7 replies
    Latest over 16 years ago
    by Juan Gonzales
  • Not Answered

    Bad Magic Number 0 Locked

    4948 views
    12 replies
    Latest over 16 years ago
    by Bernie Thompson TI
  • Not Answered

    speech1_copy example hanging on signal 0 Locked

    717 views
    13 replies
    Latest over 16 years ago
    by MinhQuan
  • Not Answered

    Incorrect checksum for bios_setuplinux_5_32_04.bin, OMAP35x DVSDK Beta 1 0 Locked

    329 views
    4 replies
    Latest over 16 years ago
    by Bernie Thompson TI
  • Discussion

    Davinci DM355 EVM problems Locked

    269 views
    3 replies
    Latest over 16 years ago
    by Bernie Thompson TI
  • Discussion

    [C6713] why does my boot-load branch instruction NOT contain an absolute address to _boot_2 ?? Locked

    703 views
    3 replies
    Latest over 16 years ago
    by Brad Griffis
<>