TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DRA821: SPL BOOT without A72 SPL on J7200 on 10.1 SDK

    Gokul Praveen
    Gokul Praveen
    Part Number: DRA821 Tool/software: How to enable Falcon Boot Mode on J7200? Boot Flow: R5 SPL -> ATF -> OPTEE -> U-BOOT -> Kernel Regards Gokul
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to avoid crashing the DM R5F when writing custom DM R5F firmware

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, on some devices (not all devices!), TI supports writing custom code to run on the DM R5F, alongside the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] SBL boot: How to find the DM R5F firmware that is loaded by SBL

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the DM R5F, alongside the DM task. The firmware running on the…
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4AL-Q1: Large byte transfer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4AL-Q1 Tool/software: Example application on SDK 10.0 to show large byte transfer between CDD IPC(MCU1_0) and Linux (A72) using cdd_ipc_rc_linux ,rpsmg_char_simple applications on J721S2 ?
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to check if Linux can communicate with a non-Linux core through RPMsg

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Before Linux can communicate with a non-Linux core over the RPMsg inter-processor communication (IPC) protocol, several things needs to be true: 1) RPMsg between Linux and the non-Linux core must be supported…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Linux: How to check what binary is running on the DM R5F

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px, AM67, AM67A The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM-Q1: How to enable cross domain UART access from PDK applications.

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM-Q1 Tool/software: On custom boards where UART instances are limited, how can I route debug output from my application running in one domain to a UART instance available in different domain? Specially, I want to enable cross-domain…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] EDGE-AI-STUDIO: TIDL RTOS tool vs edgeai-tidl-tools

    Adam Hua
    Adam Hua
    Part Number: EDGE-AI-STUDIO Tool/software: Model importing in TI has two sets of tools due to historical reasons. These two sets has developed in parallel for a long time. Here is an explanation of the similarity and difference of the two tools. …
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] What is Active Slot bitmask, Data Bitmask, and Transaction Count in MCASP?

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM62D-EVM AUDIO-AM275-EVM Other Parts Discussed in Thread: SYSCONFIG Tool/software: 1. While configuring McASP through sysConfig, I found that when the num of slots set as 2, the active slot bitmask can only below 3. What is this…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Not able to return from infinity loop in C7 core by changing the loop variable using CCS

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM275-EVM Tool/software: I am not able to return from infinity loop in C7x core by changing the loop variable from the Variables tab in CCS. In the following code - void loop_forever() { volatile uint32_t loop = 1U; while(loop…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 197750 Discussions
  • Not Answered

    Problem with Booting from Flash on DM648 0 Locked

    1700 views
    18 replies
    Latest over 16 years ago
    by Geetha
  • Not Answered

    Problems compiling the encode Demo 0 Locked

    869 views
    12 replies
    Latest over 16 years ago
    by Juan Gonzales
  • Not Answered

    Disabling interrupts in your video system and how it can affect your video drivers (DM6437) 0 Locked

    1048 views
    9 replies
    Latest over 16 years ago
    by Juan Gonzales
  • Not Answered

    Problems with DVI (DM6446) 0 Locked

    296 views
    1 reply
    Latest over 16 years ago
    by Bernie Thompson TI
  • Not Answered

    PAL and NTSC 0 Locked

    665 views
    2 replies
    Latest over 16 years ago
    by Bernie Thompson TI
  • Discussion

    C5502: McBSP with external clock Locked

    611 views
    1 reply
    Latest over 16 years ago
    by BrandonAzbell
  • Discussion

    How can I get prior versions of DaVinci DVSDK software? Locked

    210 views
    0 replies
    Started over 16 years ago
    by Juan Gonzales
  • Not Answered

    What's the "Low Voltage Adapter with Adaptive Clocking" function 0 Locked

    413 views
    4 replies
    Latest over 16 years ago
    by TimHarron
  • Not Answered

    Combining Multiple DM355's 0 Locked

    421 views
    9 replies
    Latest over 16 years ago
    by Juan Gonzales
  • Discussion

    Application interfacing with DM355 Locked

    495 views
    9 replies
    Latest over 16 years ago
    by Juan Gonzales
  • Discussion

    GPIO Locked

    260 views
    4 replies
    Latest over 16 years ago
    by Juan Gonzales
  • Discussion

    What's the easiest way to burn on-board NOR flash on a DM6467 platform? Locked

    494 views
    2 replies
    Latest over 16 years ago
    by Bernie Thompson TI
  • Not Answered

    initialization of PlaneActive field and FrameBufferObject && usage of interrupts and semaphors in dm6437 vpbe drivers 0 Locked

    248 views
    0 replies
    Started over 16 years ago
    by Elric
  • Discussion

    Dm6446 developer platform with ADS Locked

    683 views
    10 replies
    Latest over 16 years ago
    by Eric6868
  • Not Answered

    prob with acpy3_start 0 Locked

    430 views
    8 replies
    Latest over 16 years ago
    by janet
  • Discussion

    Question about the proper capacitors to use for the TMS320DM6435 crystal circuit Locked

    287 views
    1 reply
    Latest over 16 years ago
    by Bernie Thompson TI
  • Discussion

    Failed LSP1.20 patch 14 Locked

    663 views
    1 reply
    Latest over 16 years ago
    by Juan Gonzales
  • Discussion

    [C6713] Exception handling in a multitasking application Locked

    3069 views
    20 replies
    Latest over 16 years ago
    by mlimber
  • Not Answered

    [solved]whereabouts of FVID functions -as a wrapper on top of GIO class driver 0 Locked

    696 views
    9 replies
    Latest over 16 years ago
    by Elric
  • Not Answered

    Reloading u-boot on DM355 EVM (via RS232 UART) 0 Locked

    2486 views
    30 replies
    Latest over 16 years ago
    by Bernie Thompson TI
<>