• State
  • Replies 1 reply
  • Subscribers 30 subscribers
  • Views 51 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

IWR1642BOOST: Get data from IWR1642BOOST

Meisam Sharifi
Prodigy 50 points
Part Number: IWR1642BOOST
Other Parts Discussed in Thread: IWR1642

Tool/software:

Hi,

I have designed an interface board that I want to use to communicate with the IWR1642 BOOST radar via the network. Currently, I can send config through the network to RS232 and receive "done," but I am not receiving anything from the MSS logger. After receiving the "done" message from the last sensorStart command, should the MSS logger produce any output ?Do I have to do something else after sending config so that I can get the output?

I have set the baud rate to 921600.

  • 0
    TI__Genius 10400 points

    Hello.

    When trying to get data off the device, I would recommend opening two serial terminals(1 for sending the config and 1 for seeing the data output).  These two terminals will connect to the application/uart port and data uart port, respectively.  Are you switching between the same terminal?  Or are you not seeing output on the second terminal?

    Sincerely,

    Santosh