TS5A22362: 4 questions on TS5A22362 : Rdson , max current, Band, application

Hi April,

I did a search on “Ron flat” on the E2E switches and muxes forum and found the below thread:

https://e2e.ti.com/support/switches-multiplexers/f/388/t/554350

Doing a search on “TS5A22362 uart” gives the below thread:

https://e2e.ti.com/support/switches-multiplexers/f/388/t/478447

Bandwidth is defined as the frequency at which the output is attenuated by 3 dB from the pass band (DC) response.

Please see below quick video training on mux Bandwidth:

https://training.ti.com/ti-precision-labs-multiplexers-bandwidth-channel-channel-crosstalk-isolation-and-thdnoise?cu=1134454

 

Below is the absolute maximum rating for on state current specification in TS5A22362 datasheet for different setup condition, temperature and packaging. 

 

What is your application scenario? 

Thank you,

Helen

HI April,

A surface mount board is available, please see the TS5A22362 product page, under " tools and software" tab, under " device kits and evaluation modules".

www.ti.com/.../toolssoftware

Thank you,

Helen

Hi Helen,
Thanks so much for you reply.

I have another question, about IN1 and IN2 , Normally, switch to NC is closed, and NO is open .
I have a question that, when IN1 input is High , switch to NC1, and IN1 input is low, switch to NO1? If the work logic is like this?

Or only if IN1 is change the status, switch will change to another channel ( NC1 to NO1 , or NO1 to NC1 )?