I am trying to use the XDS100V3 to program an LM3S818, but I can't get even get the Jtage adapter to connect.
I attempting to us the RDK-ACIM motor development kit (which has an isolated Jtag connection).
In order to program/emulate/debug the LM3S818 I purchased the TMS320-XDS100v3_UM_Rev_B_Jtag_emulator from Olimex.
I then Installed the ti_emupack_setup_5.1.114.0.
then when I go to set up the target configuration, I get the following error message:
[Start]
Execute the command:
%ccs_base%/common/uscif/dbgjtag -f %boarddatafile% -rv -o -F inform,logfile=yes -S pathlength -S integrity
[Result]
-----[Print the board config pathname(s)]------------------------------------
C:\Users\Ethan\AppData\Local\.TI\693494126\
0\0\BrdDat\testBoard.dat
-----[Print the reset-command software log-file]-----------------------------
This utility has selected a 100- or 510-class product.
This utility will load the adapter 'jioserdesusbv3.dll'.
The library build date was 'May 6 2013'.
The library build time was '21:55:37'.
The library package version is '5.1.114.0'.
The library component version is '35.34.40.0'.
The controller does not use a programmable FPGA.
An error occurred while hard opening the controller.
-----[An error has occurred and this utility has aborted]--------------------
This error is generated by TI's USCIF driver or utilities.
The value is '-182' (0xffffff4a).
The title is 'SC_ERR_CTL_CBL_BREAK_NEAR'.
The explanation is:
The controller has detected a cable break that is near-to itself.
The user must connect the cable/pod to the controller.
[End]
the power is to the device is on, and all cables are connected. I don't know what else to do. please help me.
