TIDA-01012: about the read error sysbol "X"

user6501051

Part Number: TIDA-01012
Other Parts Discussed in Thread: CC2640, BLE-STACK

Dear TI expert,

i am learning the TIDA-01012, when i rebuild project, the build finished, no error. but the TOOLS folder has a red "X" symbol, the picture as follows:

Can you help me?

have a nice day!

over 2 years ago

0 Shaury Anand over 2 years ago

TI__Intellectual 1540 points

Hello,

We are looking into this issue. We will get back to you by the end of the day.

Regards,
Shaury

0 Shaury Anand over 2 years ago in reply to Shaury Anand

TI__Intellectual 1540 points

Hi,
Could you send complete console output? I want to check if there are any warnings. The designer of this reference design no longer works in TI. I'm trying to install the required software for this design.

Regards,

Shaury

+1 Shaury Anand over 2 years ago in reply to Shaury Anand

TI__Intellectual 1540 points

Hi,

I checked with my colleague who supports CC2640. Here is what he said. I'm closing this thread. You can reply to this thread if you need further help.

If the project builds as expected then I would not suspect an issue with the project itself. This behavior could result from not using the exact dependencies highlighted by the TIDA-01012 Design Guide:

TI’s Code Composer Studio (CCS) software (version 6.1.2), TI-RTOS 2.13.0.06, ARM Compiler Tools 5.2.5, and BLE-STACK V2.1.1 were used to develop the TIDA-01012 reference design.

Regards,

Shaury

Simulation, hardware & system design tools

Simulation, hardware & system design tools forum

TIDA-01012: about the read error sysbol "X"