WEBENCH® Tools/LM5176: Webench export to TINA-TI fails

Simon Schaak

Part Number: LM5176
Other Parts Discussed in Thread: TINA-TI,

Tool/software: WEBENCH® Design Tools

I'm trying to export a customized LM5176 design from webench power designer to TINA-TI for simulation, but the export fails. The new HTML5 based webench exports an invalid zip file of 4 bytes and the flash based webench fails with "ERROR: SimExport-80 : Error occurred while verifying the exported design..".

over 6 years ago

0 Umayal Ramanathan over 6 years ago

TI__Expert 5550 points

Hi Simon,

Thanks for reporting this issue

Could you please provide us the conditions for which you are observing this issue ?

This will help us debug the issue.

Alternatively you can share your WEBENCH design by following steps mentioned in below image.

Thanks and Regards,

Umayal

0 Umayal Ramanathan over 6 years ago in reply to Umayal Ramanathan

TI__Expert 5550 points

Hi Simon,

We didn't hear back from you. Please let us know if you are facing any issue.

Thanks and Regards,
Umayal

0 Harish K R over 6 years ago in reply to Umayal Ramanathan

TI__Intellectual 2320 points

Hi Simon,

Since we haven't heard back from you, we hope you were able to resolve the issue.
Hence we shall be closing this thread.
Please feel free to reply to this thread or create new thread in case you have any queries.

Thanks & Regards,
Harish

Simulation, hardware & system design tools

Simulation, hardware & system design tools forum

WEBENCH® Tools/LM5176: Webench export to TINA-TI fails