Linux/LAUNCHXL-CC1312R1: how to build Contiki mesh network on CC1312r1?

Thanks for the reply Tobi,

I've gone through the thread you provided also I read the Contiki-ng documentation as well.
It says "There are currently no platform-specific examples for the SimpleLink platform."

Can you suggest me any other example I can use.

Thank You,
VK

Hi Severin,

Thanks for the suggestion !!

As you suggested, I started with the hello-world program and I can compile it on native platform successfully with "make TARGET=native hello-world".

 then I compiled it for cc1312r1 with command "make TARGET=simplelink BOARD=launchpad/cc1312r1 PORT=/dev/ttyACM0 hello-world".

but when I enter "make TARGET=simplelink BOARD=launchpad/cc1312r1 PORT=/dev/ttyACM0 login" It isn't printing hello world on terminal.

can you please guide me with this.

Thank You,

VK

"make TARGET=simplelink BOARD=launchpad/cc1312r1 PORT=/dev/ttyACM0 hello-world.upload" is the command to build hello-world binary and download binary using serial boot loader. Are you sure the binary is built successfully and downloaded to your CC1312R1 successfully?

Hello Chen,

Thank you for your reply.

I have already tried "make TARGET=simplelink BOARD=launchpad/cc1312r1 PORT=/dev/ttyACM0 hello-world.upload". and this is showing me an error "*** No rule to make target 'hello-world.upload'. Stop".

Are you sure the binary is built successfully and downloaded to your CC1312R1 successfully?

Yes I'm sure built successfully. and I have also loaded it to cc1312r1 using Uniflash as well.

Thank you,

VK

I cannot build hello-world successfull by using "make TARGET=simplelink BOARD=launchpad/cc1312r1" and that's why I ask if you build it successfully.

Hi Chen,

I build hello-world with command "make TARGET=simplelink BOARD=launchpad/cc1312r1 PORT=/dev/ttyACM0 hello-world".

I got binary in build directory then I downloaded hello-world.bin into my cc1312r1 using uniflash.

Then, I run "make TARGET=simplelink BOARD=launchpad/cc1312r1 PORT=/dev/ttyACM0 login" which left me with the following screen.

Thank You,

VK

Do you see the same behavior with the CC1310?

Hi VK,
I suspect you don’t build hex or binary for hello-world successfully. What do you see if you build hello-world with command "make TARGET=simplelink BOARD=launchpad/cc1312r1"?