Other Parts Discussed in Thread: CC1190, , LAUNCHXL-CC13-90
I'm designing a custom board with the CC1312R and the amplifier CC1190 based on the LaunchPad https://www.ti.com/tool/LAUNCHXL-CC13-90.
But I want the board to be a bit smaller and I noticed the Launchad had three 0ohm resistors between the SAW filter and the CC1190 RF IOs.
Are those components necessary for a good RF performance?
For what purpose are those 0ohm resistors?
Can I just remove those resistors and put the SAW filter closer to the CC1190 and just be symmetrical with the un-balance RF signal traces on the board?
Thank you in advance for your response.