CCS/LAUNCHXL-CC1312R1: Cannot fine products name "com.ti.SIMPLELINK_AUDIO_PLUGIN [3.30.0.06]"

Have you tried  

Hi TER,

I download the wrong SDK which does not match the website. Now I've downloaded it again and built it successfully.

And your resource does not exist. :) Thanks

Best wishes,

SeanOY

Remove the question mark at the end of the link and the link works. Sometimes an extra letter is included when a link is generated hence links that doesn't work from time to time. 

Hi TER,

I would have a try, thanks. I found the driver demo pdmstream cannot generate any voice, is this the right phenomenon?

Best wishes,

SeanOY

I don't have the relevant hardware here to do a test but "Volume 0" doesn't look correct. 

Which microphone are you using and how have you connected this? 

Hi TER,

The development kits I use are LAUNCHXL-CC1312R1 and BOOSTXL-AUDIO, shown as the following photograph.

I think the turntable can change the volume, but it doesn't work. :(

Best wishes,

SeanOY

Hi TER,

I think I use the wrong DK board after I looked through the websites about BOOSTXL-AUDIO and MSP430FR5994. But which board is used in conjunction with LAUNCHXL-CC1312R1 to test audio application?

Best wishes.

SeanOY

Hi TER,

Thanks, I'll apply for a DK board compatible with CC1312 and do a test.

Best wishes,

SeanOY

Hi TER,

I received the two CC3200AUDBOOST boards and redid the test. Also, I've connected the wires as shown in the file "Board.html" and closed  relevant jumpers, but I cannot hear any sound from the receiver and receiver's red LED doesn't blink while transmitter's green LED is blinking.

The connection of devices as shown in the picture below.

Best Regards,

Sean

In the docs/Quick_Start_Guide.html in the audio plugin you will find a "hardware setup" section with a very detailed information on how to set the jumpers etc. Not sure if your current setup reflect this? 

Hi TER,

The doc you said is about the demo "audiohal_echo" which runs within one device. I've followed the steps it described but still couldn't get the correct result. :(

The steps are simple, combine the device, plug in audio input&output wires, download the program, then you can hear sound from the output side.

Best Regards,

Sean

Hi TER,

I follow this. Just now, I see the note "The setup shows two CC1352P LaunchPads. The setup is slightly different for CC13x2R LaunchPads. Please consult the User’s Guide for more info.". I'll read users guide more clearly.

Best Regards,

Sean

Hi TER,

The test has passed! But it's too noisy :( Any solution can optimize the audio quality?

Best Regards,

Sean