Part Number: WL1831MOD
Q1. have anyone know how to change channel for receiver blocking
DUT run on Debian with Bluez stack v5.34
find the below commands
hcitool cmd 0x3f 0x01fb 0x01 0xff 0x00 0x00 0x00 0x80 0x00 //disable RF Calibration hcitool cmd 0x08 0x001d 0x00
waiting some thing
hcitool cmd 0x08 0x001f
but the command only on 2402MHz,
how to change channel of receiver?
Q2. How to continues TX testing for Bluetooth/BLE
we following the below steps for continues TX testing but the TX output just a few minutes, What's step missed or mistake
1. disable sleep modehcitool cmd 0x3f 0x10c 0x00 0x00 0xff 0xff 0xff 0xff 0xff 0x642. Inquiry commandhcitool cmd 0x01 0x001 0x33 0x8b 0x9e 0x04 0x003. Write Scan Enable command to Disabledhcitool cmd 0x03 0x001a 0x004. hcitool cmd 0x3f 0x01fb 0x01 0xff 0x00 0x00 0x00 0x00 0x01----------------------------------------------------------------------------------------------DH5_2402MHzhcitool cmd 0x3f 0x01ca 0x62 0x09 0x01 0x00 0x07 0x00 0x00 0x00 0x00 0x00 0x00 0x00 0x00
Please, check the below thread for blocking tests.. It provides the details of BT test report and setup procedures..
We are glad that we were able to resolve this issue, and will now proceed to close this thread.
If you have further questions related to this thread, you may click "Ask a related question" below. The newly created question will be automatically linked to this question.
In reply to Hari Nagalla:
Thank you for your information.
my question is how to send hci commands for testing
the thread have test report and setup procedures,
but missed correct hci command set for EUT(WL1831)follow TI wiki, just have the below commands,
currently we testing on 2402MHz passed, but need verify another channel
May you know how to send change another channel command?
In reply to KunYi Chen:
Are you conducting BT SIG tests? Once, you have put the device in BLE RF receiver tests, the tester will put the device into needed mode, right? What are you trying to test?
Dear Hari Nagalla
due to our testing lab ask we to provide method,
the BT SIG tester can't to wiring to our WI1831MOD module
so need hci command
but maybe I found the answer from TI CC256x testing guide
HCI_BLE_Receiver_Test 0x201d, RX_Channel
Yes, you use hci commands to put the DUT in test mode.. Let me know, if you need any other..
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.