Hey Team,
I am reaching out to seek assistance regarding ZigBee wireless communication. I am currently working on the ZigBee coordinator project, specifically the Light and Switch - Zigbee Project Zero, utilizing the CC2652R7. I have followed the provided instruction in the link - (Link). The program built successfully, and I debugged the ZigBee coordinator (sample light) code in the controller.
However, when I tried to set up PUTTY with the correct settings ( All COM port and recommended baud rate), the terminal remains blank. Could you kindly advise on the next steps to enable the output to display correctly in the PUTTY terminal?
Regards,
Keerthivasan