Frequent Questions

  • [FAQ] PROCESSOR-SDK-AM64X: AM64x: NoRTOS: http server example static ip adress configuration

    Part Number: PROCESSOR-SDK-AM64X Hi, Problem Statement : When we run below example, After Network link up, code is waiting for certain timeout and after about 4 minutes later my netif struct gets constant ip adress. After this timeout I can ping to…

  • [FAQ] PROCESSOR-SDK-AM64X: Enet Layer 2 CPSW Example not working on AM64x MCU+ SDK 08.05.00.24

    Part Number: PROCESSOR-SDK-AM64X Hi, This is known issue with MCUSDK 8.5. Planned to be fixed in upcoming release. Note : What I am discussing here is just a workaround not a clean fix. Steps to check : Please refer https://e2e.ti.com/support…

  • [FAQ] J7200XSOMXEVM: How do I enable CAN with Linux driver on J7200?

    Part Number: J7200XSOMXEVM By default, CAN is not enabled on Linux for J7200. How can I enable CAN on PSDK Linux 8.5?

  • [FAQ] TI-API: v2 Backlog advanced ship notice (ASN) API error codes and meanings (part 1 of 2)

    Part Number: TI-API What do the v2 ASN API error codes mean?

  • [FAQ] TDA4VM: How to change the MAC-only port mapped to A72 (Linux) client in Ethernet Firmware + Linux Use Case?

    Part Number: TDA4VM How to change the MAC only port mapped to A72 (Linux) client in case of Ethernet Firmware + Linux Use Case?

  • [FAQ] TDA4VM: How is the EVM(board) to device tree mapped? How are the peripherals organized in a device tree?

    Part Number: TDA4VM There are multiple peripherals and multiple dts files. Is there a hierarchy? How can we map the dts files to the J7 board/SOM/SOC?

  • [FAQ] How to add/map MAC-only port to A72 (Linux) client in Ethernet Firmware + Linux Use Case?

    How to add/map MAC-only port to A72 (Linux) client along with default MAC Port-1 in Ethernet Firmware + Linux Use Case?

  • [FAQ] PROCESSOR-SDK-J721E: Changes required for interfacing eDP output with external serializer

    Part Number: PROCESSOR-SDK-J721E This article explains changes required in the PSDKRA driver for interfacing eDP output to external serializer.

  • [FAQ] TMS320F28379D: What is the FIT/MTBF for TMS320F2837x devices?

    Part Number: TMS320F28379D Q: What is the FIT/MTBF for TMS320F2837x devices? A: FIT/MTBF for TI devices can typically be found at MTBF and FIT Rate Estimator Currently there is a technical issue preventing data for the TMS320F2837x devices to be displayed…

  • [FAQ] ADS131B26-Q1: How do I calculate the achievable accuracy and resolution for my BMS (battery management system) current shunt measurement?

    Part Number: ADS131B26-Q1 Hello, I am developing a battery management system (BMS) using the battery pack monitor, ADS131B26-Q1. I need to measure the battery pack current using a shunt resistor with very high accuracy and resolution. My requirements…

View FAQ threads
Recommended For You