TUSB1310A (hub application)

VG OG

Other Parts Discussed in Thread: TUSB1310A, SN65LVPE512

Hi experts,

As I know, TUSB1310A is in fact a low level USB2.0/3.0 PHY layer controller. Maybe it sounds strange, but is it possible to develope 1 to 1 port hub, using two PHYs and FPGA ?

Best regards,

over 9 years ago

0 Diego Cortes over 9 years ago

TI__Mastermind 36085 points

Hello,

Yes it is possible to build a USB3 HUB using the TUSB1310A, however a 1 to 1 port HUB seems to be an option only to increase the length of a USB3 cable. If so, then you can take into account the SN65LVPE512, which is a USB3 re-derive, .

Best regards,
Diego.

0 VG OG over 9 years ago in reply to Diego Cortes

Prodigy 60 points

Hello,

Thanks for reply!

You mentioned only USB3.0 mode. Am I right, that HUB application is also possible with ULPI USB2.0 mode too?

Best regards!

0 Diego Cortes over 9 years ago in reply to VG OG

TI__Mastermind 36085 points

Hello,

Indeed, the SN65LVPE512 is for USB3 only. On the other hand, USB2 supports up to 5 meters cable. What would be the total cable length on your application?

Regards,
Diego.

0 Jose Carlos Gil over 9 years ago in reply to Diego Cortes

TI__Genius 9315 points

Hi,

We are about to release USB2.0 redriver which can be used for long cables (even more than 10m).
If you need more information about it, please email me to:
JoseCarlos.Gil@TI.com

Regards
JC

Interface

Interface forum

TUSB1310A (hub application)