TPS65982: How to confirm UART data transmission completely ?

Sam Yeh

Prodigy 40 points

Part Number: TPS65982

Hi Team,

We had met the issue that PD(65982) port 2 load FW fail, block diagram as below,

and get the pass and fail waveform from UART transmission as below,

[pass]

[Fail]

How to confirm UART data transmission completely ? (PD_UartLog file as enclosure)

PD_UartLog.7z

over 5 years ago

0 Eric Beljaars over 5 years ago

TI__Mastermind 36751 points

Hi Sam,

I am assigning this thread to the appropriate engineer. We will provide you with feedback soon.

Thanks,
Eric

0 Brad Hale over 5 years ago in reply to Eric Beljaars

TI__Intellectual 1010 points

Sam:

Is there an EC connected to the two TPS65982 devices? If so, it can read the Mode registers. For TPS65982 this will contain "APP " if the boot sequence is complete. If the booting of the device is not complete, it will contain "BOOT".

Regards,

Brad.

0 Sam Yeh over 5 years ago in reply to Brad Hale

Prodigy 40 points

Hi Brad Hale,
Could you please help us to check the setting of PJT file, for security concern, may i provide PJT file to you by e-mail,
could you help to provide your e-mail address?

0 Sam Yeh over 5 years ago in reply to Brad Hale

Prodigy 40 points

Hi Brad Hale,
Yes, we read the Mode registers and contain "BOOT".

0 Brad Hale over 5 years ago in reply to Sam Yeh

TI__Intellectual 1010 points

Do you see cases that pass and cases that fail? If so, what changes are to the hardware and/or firmware have been done to create the fail condition?

Interface

Interface forum

TPS65982: How to confirm UART data transmission completely ?