Texas Instruments (TI) C2000™ microcontrollers support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search C2000™ microcontroller content or ask technical support questions on our families of real-time control MCUs. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Part Number: F29H859TU-Q1 Tool/software: Note: This page will continue to be updated as necessary for relevant information to the FAQ.
Question: Where are the Flash Settings for my device in CCS?
Answer: In order to reach the Flash Settings, proceed with…
Part Number: C2000WARE
Tool/software:
Situation example:
The CMPSS's compared voltage is set as 1.5V from internal DAC / external signal, once the sensed voltage on positive pin is higher than negative pin 1.5V, then trigger ONCE interrupt. Then…
Part Number: C2000-SAFETI-DIAGNOSTICS-LIB Other Parts Discussed in Thread: C2000WARE
Tool/software:
How can I use the C2000-SAFETI-DIAGNOSTICS-LIB in an EABI project when existing .lib files are COFF ABI?
Other Parts Discussed in Thread: TINA-TI , ADS8364 , TMS320F2812 , PSPICE-FOR-TI , TMS320F2811 , TMS320F2810 , TIDM-02006 , ADS8361
Where can I find IP/peripheral collateral and FAQs for C2000 devices?
Part Number: C2000WARE
Tool/software:
When sharing, exporting, or migrating CCS projects there may be issues with building the same project due to paths being incorrect.
The error below is an example
or the following
gmake: Target 'all' not remade because…
Part Number: C2000WARE Tool/software: In some systems, noise on the JTAG pins/traces will result in the debug architecture of the MCU issuing commands that stop the operation of the MCU.
In the following devices, this problem can sometimes be mitigated…