Part Number: ADC08D1000 Tool/software: Dear Specialists,
My customer is evaluating ADC08D1000 and encountering the problem.
I would be grateful if you could advise.
---
I'm encountering an issue with the ADC08D1000 where the settings differ from…
Part Number: ADC08D1020 Other Parts Discussed in Thread: ADC08D1000 , Hi team,
What is the difference between ADC08D1020 and ADC08D1000 except for bandwidth?
Can you provide a comparison table? thanks
Other Parts Discussed in Thread: ADC08D1000 Hello Everybody,
We want to evaluate the performance of the ADC08D1000 but we have some troubles to reach the performance of the device. The component is soldered on ROGER R007 PCB board.
The PCB Board is…
Other Parts Discussed in Thread: ADC08D1000 , ADC08D500 , ADC08D1500 Dear specialists,
My customer is encountered the trouble of ADC08D1000.
Could you please advise him .
The detail is following.
<<<question>>>
Device:ADC08D1000
according…
Part Number: ADC08D1500 Other Parts Discussed in Thread: ADC08D1000 Hello Sir,
On the die of part# ADC08D1500, it shows ADC08D1000A, rather than ADC08D1500, please help check if it's correct marking?
Or it is actually marking for part# ADC08D1000…
Part Number: ADC08D1020 Other Parts Discussed in Thread: ADC08D1000 One of our designs is migrating from the ADC08D1000 to the ADC08D1020. The FPGA designers are asking about the setup and hold times on the data interfaces. The ADC08D1000 datasheet has…
Hi Eddie,
See attached for pin functionality differences. A common pcb can be used.
The configuration register details have some differences. If the customer is using extended control mode (config registers) then their FPGA firmware will need to write…
Hi Bugra
The ADC08D500 device does not include an output data test pattern. There is a pin compatible device which does have that feature, the ADC08D1020.
It is possible to design a board that can accommodate both devices, please see this document…
Hi jlin
I have a few other comments related to the ADC operation and usage.
Since you will be using this converter in DES (Dual Edge Sampling) mode please note that you must return the device to non-DES mode whenever an on-command calibration is required…
Other Parts Discussed in Thread: LMH6518 , ADC08D1000 Initial conditions the LMH6518 set to Low Gain mode.
The +IN of LMH6518 is connect with a DC(+2V) + Squared waveform(2Vp-p 100kHz).
The -IN of LMH6518 is connected with a DC(+2V).
The VCM is…