Part Number: ADC10040 Hello, I have implemented in single ended mode the ADC10040 as described in page 20. I am observing that the digital output D0-D9 is stuck to 0 until the Vin signal reach around 350mV. Then upper 350mV, the output seems to start…
Part Number: ADC10040 Other Parts Discussed in Thread: ADC10D040 Hi team,
one of my customers would like to use this device with an external Vref =1V.
Divider from 2.5V with 1.5k/1k with a bypass capacitor of 0.1uF.
Do you see any issue in this condition…
I find the description of the IRS pin confusing. While the pin description indicates it has 3 states, tied high, tied low or open, several graphs plot a value, IRS, that varies continuously between 1V and 2V. Is this the same IRS?
If so, the graphs indicate…
Part Number: ADC12DJ5200RF Other Parts Discussed in Thread: ADC12DJ3200QML-SP , AMC1336-Q1 , TLV2544Q , THS1408-EP , ADC10040 Hi Team, Our customer would like to confirm these several TI parts for their application. They want to calculate the instantaneous…
Hi Jacob,
I surfed ADC selection a little and I have found ADC10040 fits better for the application.
I have 3.3V and 5.1V. With a voltage doubler I make -5.1V and 10.2V for the input stage and all the rest works from 3.3V.
I think it fulfills all the…
Although Your Recommended ADC32RF80 Series Seems No Automotive Grade Parts To Select. We Need Automotive Rating And Not Sure Which One Would Be Suitable:
TLV5535-Q1 / ADC08B200-Q1 / ADS5204-Q1 / ADC10040-Q1
Other Parts Discussed in Thread: ADC10080 , ADC10040 , LMH6550 Hi Team,
Please allow me to ask you question about admissible load to VREFB and VCOM pin of ADC10080.
I understand ADC10080 recommends not to connect loads to these pins, however, customer would…
Hi Yu,
The ADC10080 family (including the ADC10040 and ADC10065) gets a lot of interest from customers, sells reasonably well, and occupies and strategic portion of the TI portfolio with few alternatives, so I don't think it will go EOL anytime soon.…
Hi Aaron
I think I had an error in my earlier table due to how I reduced from full 10 to upper 6 bits.
I have attached a spreadsheet giving the full 10b response for nominal FSR and VCOM. Those parameters can be adjusted to see how the the equivalent…
