Search tips
Showing 3,540 results View by: Thread Post Sort by

  • CC1101: GDO0 continue toggling interrupt issue

    Part Number: CC1101 Tool/software: I am using the Interrupt configuration 0x06 [6 (0x06) Asserts when sync word has been sent / received, and de-asserts at the end of the packet. In RX, the pin will also deassert when a packet is discarded due to address…

  • CC1101: Packet filtering with CRC

    TI Thinks Resolved
    Part Number: CC1101 Tool/software: Hi, I am trying to configure CC1101 in a way that it only receives successfull CRC packets with address filtering. Therefore, after enabling the address filtering at PKTCTRL1 register I looked at the GDOx_CFG table…

  • CC1101: Is there any way to achieve full-duplex communication between CC1101s?

    Part Number: CC1101 Tool/software: dears, my customer is planning to use CC1101for elevator repeater, from the manual that CC1101 is a half-duplex chip, and the sending mode and receiving mode are controlled by software configuration. the repeater need…

  • RE: CC1101: IC to IC Variation in Output Power and Sensitivity

    Hi, I am marking this as resolved as I have replied privately. Regards, Zack

  • CC1101: Package Drawings

    TI Thinks Resolved
    Part Number: CC1101 Tool/software: Hello E2E Experts, Good day. Why are there two package drawings on the datasheet and which one is correct? Regards, TICSC
    • Answered

  • CC1101: TrxEB Command Strobe Timing

    Resolved
    Part Number: CC1101 Tool/software: Hello, I had 2 questions regarding the timing of command strobes. 1. After filling up the TX FIFO, the TrxEB waits 97us before sending the TX command (0x35), is there a reason for this? 2. Whenever its about to start…
    • Resolved

  • CC1101: Analog RF transmission IC?

    TI Thinks Resolved
    Part Number: CC1101 Other Parts Discussed in Thread: TLV320AIC3204 Tool/software: Hello, Does TI have an IC that would enable me to pass it analog audio on the input so that it would send it off over RF? Then I'd need the matching RF received IC on the…
    • Answered

  • CC1101: TEST1 & TEST2 Register Values

    Resolved
    Part Number: CC1101 Other Parts Discussed in Thread: TEST2 Tool/software: Hello, Could someone please clarify the significance of the TEST1 and TEST2 register values being set to 0x31/0x35 or 0x88/0x81? I was unable to locate any relevant information…
    • Resolved
    • Answered

  • SMARTRFTM-STUDIO: Packet RX Window - Maximum Number of Logged Packets (CC1101)

    Resolved
    Part Number: SMARTRFTM-STUDIO Tool/software: Hello, I’m using SmartRF Studio with a CC1101-based setup and running long-duration tests using the Packet RX tab. My goal is to leave the receiver running for several hours and, at the end of the day, export…
    • Resolved

  • RE: CC1101: Seeking TI’s Best ISM Band Chip for Mesh Networking with Multi-Hop Routing

    Hi Alex, please see below answers to your questions. 1) BLE Wi-SUN DMM Unfortunately we can not run BLE and Wi-SUN simultaneously but we have the option to start and stop the BLE stack. Meaning you could trigger the comissioning mode when running Wi-SUN …

Didn't find what you are looking for? Post a new question.