Part Number: AM6422 Other Parts Discussed in Thread: SK-AM64B , , CDCLVC1310 , TUSB4020BI , SYSCONFIG , AM2434
Tool/software:
Hi,
In AM6422 evaluation board SK-AM64B. It connect the EXT_REFCLK1 to CLKOUT0 signal. i have some question about it. …
Part Number: CDCLVC1110 Other Parts Discussed in Thread: LMK00101 , CDCLVC1310 hi Experts
do TI have p2p solution against 5PB1110NDGI8?
I check the datasheet in 5PB11xx family
find5PB1110NDGI8 is VFQFPN package . and CDCLVC11xx family only…
Part Number: LMK1D1208I Other Parts Discussed in Thread: CDCLVC1112 , CDCLVC1310 , LMK1C1104 Hi Team,
We suggest this solution to customer. and they have few question as below: -- If our clock requirement is 25 MHz, should we change the local oscillator…
Hello Joe,
We don't have an 8-output LVCMOS part that can take LVDS but we do have a 10-output part, that those. Here it is: CDCLVC1310 .
Good Luck,
Andrea
Part Number: AM2431 Other Parts Discussed in Thread: CDCLVC1310 The MCU_OSC0_Xn input has required parameters when using a crystal. (Table 7-17 and Table 7-18) But we don't specify requirements for an LVCMOS input.
CTRLMMR_MCU_HFOSC0_CTRL (TRM) can…
Helo Alen O
CDCLVC1310 has low noise at high freq. But not at low freq. like as below table.
Freq
CDCLVC1310
Rubidium Clock
10Hz
-90
-130
100Hz
-118
-140
1kHz
-138
-150
10kHz
-159
-155
100kHz…
Hi Meredith,
Unfortunately we do not have a single chip solution that will meet these requirements. The customer may be interested in CDCLVC1310 or CDCLVC1112. We could propose an alternative multichip solution depending on the application requirements…
Hi,
300MHz is ok to use for this case. In my experience even 56.25MHz would be ok for 10Gbps serial rates and below so long as the clock source jitter performance is good.
I'd suggest to look at TIs portfolio of frequency synthesizers and oscillators…
