Part Number: CDCVF2310 Other Parts Discussed in Thread: LMK00101 Tool/software: Good afternoon,
For a project where a MC drives 10 other chips using the SPI protocol, I am using a CDCVF2310 to replicate the SCK signal before I pass it to the devices.
…
Part Number: CDCVF2310 Hi Jennifer,
Thanks again for your answers.
I would like to ask:
1. How do I calculate the minimum serial resistor that will keep current bellow rating of +/- 50mA,
Is it 3.3V/ 50mA? 3.3V/ 100mA ? else ?
I guess the "dark side…
Part Number: CDCVF2310 Hi I have a 3.3V OSC and I want to feed the CDCVF2310PW from this OSC (at its "CLK" pin). However, the target FPGAs which require the clock are working at 2.5V and therefore I want to feed the CDCVF2310PW driver from Vdd…
Part Number: CDCVF2310 hi Lane:
I still want to know If the output needs to be matched with the characteristic impedance of the 50 ohm transmission line, how much resistance should the output series,Is there any documentation I can refer to?
The output impedance typically includes the resistance of the MOSFET, as this is the way output impedance is measured. Due to the age of these devices, design support is limited, I cannot confirm definitively
Kind regards, Lane
Part Number: CDCVF2310 Hi,
In order to evaluate the use of this device (CDCVF2310) in a new constelation satellite, we have to chek the radiation behaviour. Since different event can affect to de device depending on thecnology, please, could you let me…
Part Number: CDCVF2310 Hello
I have a card using the CDCVF2310PW chip as a clock distributer.
It receives a 3.3V TTL 100MHZ clock as an input.
Only the first bank is activated and I use it to generate four 100MHZ clocks, two for TLK2711 SerDes and 2 for…
Part Number: CDCVF2310
In its Datasheet under the recommended operating conditions no maximum value is written for the Vih under VDD=2.3 to 2.7 V.
Is that mean, that 3.3v or any other voltage smaller than the Absolute Maximum Rating limit is tolerant in…
