Search tips
Showing 20 results View by: Thread Post Sort by

  • DAC3151 - Example and settings to get the first signal out

    Other Parts Discussed in Thread: DAC3151 Hello system team, do we have a configuration example on how to get the test patterns out of the DAC? For the 10bits, how shell I write the value in the register that contains 14 bits? (left justified or right justified…
    • Answered

  • Missing information in DAC3151 datasheet

    Resolved
    Other Parts Discussed in Thread: DAC3151 , DAC5672 , DAC3283 , DAC3174 Hello, I am using DAC3151 in my application. First of all, there are lots of errors in the datasheet due to copy/pasting. For example, if you take page 7, I can read: DATA13P/N is most significant…
    • Resolved

  • THS3491: Use as post DAC amplifier

    Part Number: THS3491 Other Parts Discussed in Thread: DAC3151 , , THS3217 , THS3215 , THS3091 Hi all, I am intending using the DAC3151 followed by THS3491 in an application that requires driving a +/- 8V into 100 ohm load at over 100 MHz. Noise and distortion…

  • ADC07D1520: Problems dealing with the ADC output data

    Part Number: ADC07D1520 Other Parts Discussed in Thread: DAC3151 Dear Texas Instruments, We have designed a circuit with an ADC07D1520 and DAC3151 on an embedded system managed by an FPGA. We are having some problems dealing with the ADC output data.…
    • Answered

  • DAC3174: DAC3174 layout example

    Resolved
    Part Number: DAC3174 Other Parts Discussed in Thread: DAC3164 , DAC3151 , DAC3171 , DAC3154 , , DAC3161 Hi, In DA3174 datasheet (SLAS837B –APRIL 2013–REVISED JANUARY 2017) Pins 63,62,52,51 are marked as NC in "Pin Functions" Table it is mentioned…
    • Resolved
    • Answered

  • RE: DAC5672A: vs DAC5672, can the "A" version be used with 1.8V DVDD and 3.3V AVDD

    Resolved
    Hi Nick I think DAC3171 should meet your requirements. http://www.ti.com/lit/ds/symlink/dac3151.pdf Regards, Neeraj

  • RE: Is there a high-speed DA, which is used in vGA applications, single-channel, 10-bit, requiring an interface level of 1.8V;

    Elsa: You can check out the DAC5652 CMOS dual, 10-bit DAC operating at 275 MSPS or the DAC3151 LVDS single, 10-bit, 500 MSPS DAC or the DAC900 CMOS single, 10-bit, 165 MSPS. --RJH

  • DAC3151EVM: DACCLKP/N AC coupling and simulation

    TI Thinks Resolved
    Part Number: DAC3151EVM Hi, I saw this termination in evaluation module of DAC3151 at the receiver end and the following termination at transmitter end at CDCE62005 I had the following doubts: 1) Why is the 100 ohm termination given at DAC3151 side…

  • Product Suggestion

    Answer Suggested
    Other Parts Discussed in Thread: BUF602 , DAC3151 , UCC27531 , UCC27538 Hello all, A customer ask, " I'm looking for an experimental solution to evaluate dynamic adaption of high speed gate drive waveform. While an immediate replacement for proper gate drivers…

  • DAC3171: DAC3171 7 LSB bits issue

    TI Thinks Resolved
    Part Number: DAC3171 Hello everyone! We use custom board with Kintex-7 FPGA and DAC3171 with 14-bit data bus (Fs = 250 MHz, two's complement ). During DAC3171 setup we noticed that lower 7 data pins (D[6:0]) make no impact onto the output analog signal…

Didn't find what you are looking for? Post a new question.