Part Number: DRV134 Other Parts Discussed in Thread: INA217 , TINA-TI Hai,
I am using DRV134 device as line driver in my audio bus application. The bus consists of two DRV134 devices with the outputs shorted together i.e +V0 of one device is shorted with…
Part Number: DRV134 Other Parts Discussed in Thread: OPA1662 , OPA1641 Hi,
We have requirement for 4 channel line driver IC. Requirement is to take 4 channel single ended audio from DSP and provide pre-outs in the audio head unit for external amplifier…
Part Number: DRV134 Hello,
I'm working on calculating the power dissipation from the DRV134 in my circuit. There doesn't seem to be any mention of it in the datasheet other than the Iq and many of the internal resistors in the functional block diagram…
Part Number: DRV134 Hello,
I would just like to confirm my understanding of a datasheet spec. I am using the DRV134 in an application that is expected to experience lightning strikes and want to make sure the DRV134 can handle the brief high voltage…
Part Number: PCM1821EVM Other Parts Discussed in Thread: PCM1821 , PCM4201 , DRV134 Hi
PCM1821 transmits 32-bit two-channel data. The customer's product actually only has a mono signal. When the back-end MCU receives the I2S dual-channel data, it needs to…
Hi Archie,
I believe section 8.4.2 of the DRV134/135 datasheet covers this topic.
DRV134 is shown in the figure, but this configuration is valid for the DRV135 as well.
Thanks,
Zach
Hi Mehmet,
Our line driver portfolio features single-ended to differential like DRV134 and DRV135 or differential to single-ended like DRV6xx family. Perhaps you can just look into fully-differential op amps: Fully differential amplifiers | TI.com
Best…
Other Parts Discussed in Thread: DRV134 Hi,
I am using the DRV134 to output a 10VDC signal to power a strain gauge bridge.
The load can vary anywhere from 1.1K to higher. There is also a lowest value of 750ohm.
Looking at the performance curve on on page…
Other Parts Discussed in Thread: DRV134 I want to use the DRV134 to send an audio signal down a metre of shielded twisted pair to a differential DAQ card with 100M ohm input impedance.
Is it best to add a load resistor at the DAQ input to achieve 600…
Part Number: INA1650EVM Other Parts Discussed in Thread: INA1650 , DRV134 , INA134
Hello, I have a few questions about using the INA1650 as a differential line driver (per Fig 62 of the datasheet): 1) I would like 3 independent outputs, so the input signal…
