Part Number: INA129-EP The application I am designing for requires that an input voltage must be on prior to ± Vcc. Will this damage the chip or will the OVP protect the circuit given the input voltage will always be less than 10VDC? Additionally…
Part Number: INA129-EP Other Parts Discussed in Thread: INA129 , INA828 For INA129-EP, if I use single power (With Vs+ to 10V and Vs- to GND), can I connect REF to GND?
Part Number: ADS8689 Other Parts Discussed in Thread: INA129 Hello,
I considering analog input circuit board that uses ADS8689.
I am thinking of connecting the INA129 instrumentation amplifier IC to the AIN_P pin of the ADS8689. (The INA129 outputs signals…
Part Number: INA129 Hi Team,
The following figure shows the weighing circuit built with TI's ina129ua / 2K5, input pin sensing mV level, output to MCU ADC pin,
Now there is a problem that the output has oscillation, there will be a 50 Hz square wave…
Part Number: INA129 Other Parts Discussed in Thread: INA818 Dear Sir,
We are planning to use INA129UA in our existing design.
In view of the above we want to know the end of life of the product.
Regards,
Arun P
Part Number: INA129 Hi, The safe input voltage of the INA129 is given as +/-40V. Is this irrespective of gain setting? Meaning, if I have +11V across the inputs with a gain of 50x, will the part be overstressed? The supply voltages on the amplifier will…
Part Number: Hi everyone,
I have a sine wave going through a circuit of R and C in series. R = 20kohm, C = 300pF. The sine wave signal is 20V pk-pk at 1kHz.
I connect the +in and -in of the INA 129 at the two sides of the resistors. So, the +in reads…