Part Number: INA200-Q1 Other Parts Discussed in Thread: INA200 , INA201 , INA202 , INA293 , INA290 Hello support team,
My customer ask INA200-Q1 output when negative load current. Is INA200-Q1 output pulled down to GND with 300mV offset? Is my understanding…
Part Number: INA200-Q1 Other Parts Discussed in Thread: INA200 Hello Support team,
I can find the below typical application in the datasheet.
According to Table 1,
V OUT_TRIP = I TRIP x R SHUNT x Gain = 1A x 5mΩ x 20V/V = 0.1V
R2 / (R1+R2…
Part Number: INA200-Q1 Hi team
INA200-Q1 D/S say Input bias current = Max 16uA at VIN- pin..
so total input bias current would be Max 32uA(= 16uA x 2) for two input pins ?
further, may I know total input bias current for two input pins at Vs …
Part Number: INA200-Q1 Hello,
Regarding to Quiescent current on INA200AQDGKR-Q1, my customer is asking a question.
They will use this device for automotive application (interior accessory).
(Question)
They need minimum data of quiescent current…
Other Parts Discussed in Thread: INA200-Q1 , INA200 What is the leakage current of INA200-Q1 from Pin Vin+ and Vin- with 16V connect to them when no power connect to pin1 V+?
Hi, I'm disty of Japan aria. Please help me.
My customer need data of Temperature Variability owing to individual differences. Please give me a material of [Output Voltage vs Temparature ]. *Input voltage is not change, Temperature range is -40 to 125…
Part Number: INA300 Other Parts Discussed in Thread: INA200-Q1 , INA200 , , INA293 , TLV3201 Dear Team,
Due to PD 3.1 will support EPR (up to 48V voltage), my customer requires a solution to replace previous INA300A.
Could you help to recommend…
Part Number: INA240-Q1 Other Parts Discussed in Thread: INA200-Q1 , INA200 , INA301 , INA301-Q1
Hello
Do you have roadmap about INA240-Q1 with comparator ?
My customer is using INA200-Q1 for several years but hope to have low offset.
80V CMR is…
Hi Peter,
Data rate is 250kbps maximum.
current is 20mA = low, 70mA( or selectable between 40mA to 70mA) = High.
I need Q100 device.
Do you have a plan to release Q100 version of INA381?
Or INA200-Q1 could be a candidate?
regards,
Hello Sharina,
The input bias currents (IB) do not vary much with the supply voltage (VS) once VCM > Vs or VCM < Vs, where VCM is the common-mode input voltage of the input pins IN+/IN-. So if VCM is 12V, the input bias currents wont vary much over…
