Part Number: INA226-Q1 Tool/software: Hi, Support Team
we saw INA226-Q1 operating temp is -40 to 125 deg , if over spec TA is -50 deg , the ic fail rate and failure mode?
if any suggestion, Please advise me.
Thnaks,
Best regards,
Lawrence
Part Number: INA226-Q1 Other Parts Discussed in Thread: INA226 Tool/software: Hello team,
Is there any situation will cause abnormal I2C communication between the host and INA226: no response to the host (either ACK or NAK) for a long time, and the I2C…
Part Number: INA226-Q1 Other Parts Discussed in Thread: INA226 Tool/software: We use INA226 to measure the current output of a half-bridge, directly reading the shunt voltage, i.e. the Shunt Voltage Register register, with a shunt resistor of 1m ohm.…
Part Number: INA226-Q1 Other Parts Discussed in Thread: INA226 , INA238 , INA228
Tool/software:
Would you have any suggestions for modifications to the schematic?
Part Number: INA226-Q1 Other Parts Discussed in Thread: TMP102-Q1 INA226-Q1 and TMP102-Q1 both show I2C fast mode and ultra-fast mode only. In our application, the clock frequency is at 100Khz or lower. Should we use the Industry standard Standard Mode…
Part Number: INA226-Q1 Other Parts Discussed in Thread: INA181 , INA226 , INA238 , INA228 , SYSCONFIG Hey,
Our HV BMS Application requires current measurements ranging from 0-2000A out of which 2000A is the peak current during overcurrent or short circuit…
Part Number: INA226-Q1 Hi Team,
May I know why the t(HDDAT) in INQ226-Q1 datasheet requires 10ns?
For other device, the min requirement should be 0ns.
So we're curious about why this one is different from other devices.
Since this parameter require…
Part Number: INA226-Q1 Other Parts Discussed in Thread: INA226 , INA236 , SYSCONFIG Can you provide me some sample SW code for using I2C device "INA226-Q1"?
Part Number: INA226-Q1 What is the maximum pull up voltage that can be applied to the alert pin of the INA226-Q1? The datasheet seems to imply 6V but I was wondering if it could be pulled to a higher voltage, ie, 28V?
