Part Number: INA233EVM Other Parts Discussed in Thread: TI-SCB Hi, I have an INA233EVM Rev B and am looking for the user guide and schematics, the only available ones are for Rev A which is very different
Part Number: INA233EVM Other Parts Discussed in Thread: INA233 Tool/software: Hi,
I'm using INA233 EVM (Rev.B) but i can't find any docs about EVM(Rev.B)
anyway, The experiment was organized as the block diagram below.
**POWER (9V~15V is disabled…
Part Number: INA233EVM Other Parts Discussed in Thread: INA233 Hi,
Firstly, I have an issue with calculating the value for current using the value from the 8C register. I am using i2c/PMBus (little endian format) commands to read and write to the registers…
Hello Stefano,
Do you mean reading two INA233s with a USB-to-GPIO EVM? This should be a viable solution. You could also use the USB-SM-DIG adaptor as well. This comes with the INA233EVM and works with the INA233EVM GUI software.
Hope this helps. …
Part Number: INA233
I'm using a INA233 from an INA233EVM Kit.
I connected the board to a Mikrocontroller (nRF9160) via I2C.
The chip runs at 3.3V and monitors the power supply of the nRF9160 (VBUS also 3.3V, shunt 100mOhm, I between 25µA and 200mA…
Hello SHH,
I am looking into your issue. Unfortunately our IT has blocked installation of the INA233EVM software for the moment, while I wait to fix that issue. Perhaps I can get a few more details from you and your customer to determine whether the…
Part Number: INA260EVM Other Parts Discussed in Thread: INA233EVM , INA226EVM , I'm looking to choose between the INA260EVM, INA226EVM, and INA233EVM. The integrated shunt resistor of the 260 is nice, but not absolutely required. I'm wondering if I can…
Hello Karen,
Thanks for using the forum to answer your question.
Question I have is when you are comparing the measurements do you make the current and the bus voltage measurements as well? Is it the current or bus voltage that does not match your…
SMART,
While I'm checking out your other questions in the lab today, I'll see about this as well and let you know what I find. For reference, I'll be using the INA233EVM to validate the addresses.
