Part Number: INA351 Other Parts Discussed in Thread: INA181 Tool/software: Hi Team,
What's the main spec and application differences between INA351 with INA181? Besides the common mode voltage stress. Thanks in advance.
BRs,
Francis
Part Number: INA351 Hi, In my design I used INA 351 for instrumentation amplification in EEG sensor. I simulated my design and everything was working properly, but on PCB I couldn't get logical output. In the datasheet of the INA351, it is written th…
Part Number: INA351 Please confirm and respond by 22th December that following products do not contain the substances restricted by RoHS10 (*) more than threshold.
RoHS10 : (EU)2015/863,2011/65/EU
Manufacturer Part No. : INA351CDSIRUGR
Part Number: INA351 The datasheet for the INA351 lists the GS pin as floating, Logic0 or Logic1. However it is unclear if Logic0 level is the negative power supply rail of the amplifier or ground, if a split rail supply is used. That is, for a Gain=10…
Part Number: INA185 Other Parts Discussed in Thread: INA351 , INA181 , , INA281 , INA213 , INA191 , INA190
Dear Community,
We're working on 2 highly cost-sensitive application use cases where we have to measure the voltage drop across a Resistor connected…
Part Number: INA351A Other Parts Discussed in Thread: INA351 Tool/software: hi Expert,
The INA351 uses a single supply of 1.8V power,add a offset reference power supply 0.8V to Pin 5,The schematic diagram and layout is as follows:
Adding a bias of 0…
Yes, R1 can by a digipot. And driving the reference input with an opamp is commonly done. (The are devices like the INA351 that integrate such a buffer.)
Jacob,
Much appreciated for the quick response! I will investigate more appropriate diodes for my application. Also, thanks for the tip on INA351, I hadn't seen that part before. Although it's very helpful to have the integrated reference buffer, I suspect…
Part Number: TLV9062 Other Parts Discussed in Thread: INA351 Tool/software: Hi E2E
I am using TLV9056 as a differential amplifier to amplify the output from the current transformer (1:1000) of input frequency of 50Hz, this is to measure the line currents…