Hi Joseph
1. On the problematic boards, we measured the waveforms at X1 and X2, as shown in the figure below:
2. The specification sheet for the crystal oscillator we used:
7B20000023.pdf
We also observed an interesting phenomenon: the failure…
Part Number: LM614-MIL Other Parts Discussed in Thread: TL103W , LM4041D , LM324 , LM4041-N , LM324B , LM324-N , TL103WB Hello,
I need to replace a Texas Instruments operational amplifier that is no longer manufactured LM614. Is there a replacement…
Tool/software: hello pls confirm p/n LM117HVK is no more available
also available the MIL PART / 883
that means it is exactly the same product but with MILITARY TEST correct?
exist a cross reference between the two parts'?
Hi Yuyama-san,
Please see the attached for a data packet with general information on PCN20250326007. We do not have specific data collected for the INA133 as this PCN used INA105 as the representative device for the characterization comparison section…
OK, this sounds good. How does one know though, that LMC6081AM refers to the MIL version? In the orderable parts section of the (latest) datasheet the letter M seems to designate PDIP instead of SOIC (Letter N). The LMC6081-MIL product page on ti.com…
Hi,
?? ?? said: - allowing Number of vias
We recommend no more then 2 vias
?? ?? said: - allowed Length of via stubs
N/A. Try to minimize vias as much as possible. Typically go from top layer to bottom
?? ?? said: - maximum length limit
Depends…
Hello,
I am Components Application Engineer @ Raytheon in Tucson, AZ.
We are planning on using TI SNJ54LS164J 8-BIT Parallel-Out Serial Shift Register, as a replacement for M38510/00903BCA, which has obsolescence issues.
Our design partner has…
Hi Vaibhav,
1. I'm reading the Interrupt count and Log address register (0x000A) and Master Status and reset register (0x0001) using direct access method in which we are not using any MAP register.
2. We are reading Remote terminal operational status…
Hi Aviad,
I sent you a friend request and can share the layout files with you via direct message once you accept for your reference.
I think I understand your question now. I believe the issue is if a tolerance were to be established there would be…
Part Number: DS90UB960-Q1
Dear Team,
We are using DS90UB960-Q1 n our design. The layout guideline says ". Minimize intra-pair and inter-pair length mismatch within a single CSI-2 TX Port (recommended <= 5 mils)."
Our layout team is not able to…
