Part Number: LM358 Other Parts Discussed in Thread: OPA2990 , , DAC0808 Hi Team,
Pls refer below link for the issue description.
DAC0808: dac working issue - Data converters forum - Data converters - TI E2E support forums
We have captured images at U5…
Part Number: LM358 Hi, Support Team
Please review as below schematic, have any concern?
Note: TA:45 deg
if any, Please advise me.
Thanks,
Best regards,
Lawrence
Part Number: LM358 Other Parts Discussed in Thread: LM2904 , TLV9002 Hello, I am working on a basic AC 5Vpk to DC (0-5V) signal converter, where AC input both phases are converted to 0-5V output. For some reason, I cannot understand why my output is limited…
Part Number: LM358 I have a LM358 in a non-inverting setup with a 12V supply. I have observed a gain of around 3.5 using a 200 ohm and 75-ohm resistor, however the output clamps around 9.63V even though the power supply is at 12V. Is there a max output…
Part Number: LM358 Dears,
We use LM358 as d ifferential amplifier circuit, but the output distortion. The VREF has been changed to 1V, but the output is still distorted. The circuit diagram and waveform are as follows.
Part Number: LM358 Hello, I designed a buffer circuit using two LM358, please refer to the attached picture.
A 1KHz, 2.19Vpp sine wave was applied to pin 3 of U1.
However, as a result of measuring the waveform at output pin 1 of U1, the output is similar…
Part Number: LM358 Other Parts Discussed in Thread: , LM324B Hey, by providing a DAC input, I'm using the LM358 as a voltage amplifier to produce a 0-10 V signal. The image is included below. V_Supply_Filter is a 24V I want to ask if I can remove the…
Part Number: LM358 Other Parts Discussed in Thread: TL072H Hello Team, I am designing a circuit to measure the intensity of light. I am planning to build a trans-impedance amplifier using LM358 opamp. Is LM358 a good choice for me? The application note S…
Part Number: LM358 Other Parts Discussed in Thread: LMV2011 , Hello,
I designed current source circuit for LED.
I didn't understand how it works.
I changed only the OP AMP in the same circuit, but the simulation operation does not work with the LM358…
