Other Parts Discussed in Thread: LM392-N , LM393 , LM358 Hi Experts,
We would like to ask your assistance between these two subjected dual op-amps. Are they considered replacement with each other?
Sorry if I couldn't really understand what are these…
Part Number: LM392 Other Parts Discussed in Thread: TLV2302 , , LM358 , TSM102 , TLV7021 , TLV9051 Hi,
LM392M (SOIC-8) is rated to work from 0°C to 70 °C, I was wondering if there is an equivalent part with the following temperature rating -40 °C to…
Other Parts Discussed in Thread: LM392 , LM393 , LM358 , TINA-TI I'm looking for an LM392 spice model, but I see that one doesn't seem to exist. Is there another part I can use for simulation. I'm not using the part for a high speed application, I'm just…
Other Parts Discussed in Thread: LM392-N Hi Team,
I am looking for the Integrated Amplifier with latched output comparator. With below mentioned specification.
Input Voltage = 2.5V to 36V
Gain =5 or less then 5
slew rate= 30V/uS
Automotive Qualified…
Hello Joseph,
Yes. You can make a comparator into a very POOR amplifier if needed. But usually a open-collector/drain output is used and not a push-pull.
See section 21 of Appnorte AN-74:
A Quad of Independently Func Comparators (Rev. A)
The output…
Hello Chaitanya,
Can you clarify your request? Most of the combination comparator and op-amp devices (LM392) are too slow for 10MHz.
What are you trying to accomplish?
Regards,
Hello Ricardo,
Actually, comparators can be turned into very poor amplifiers with NO output current drive, limited bandwidth, horrible distortion and high offset voltage. If that sounds good to you...then, yes, you can... But you will need to add several…
