Part Number: LMH5401 Tool/software: Dear TI teams,
We have a input single-ended signal with Vcm=0.4V, Vpp=0.5V,
and we want to use LMH5401 to amplify the signal to a single-ended signal with Vcm=0.55V, Vpp=0.5V.
How should we design it?
Please…
Part Number: LMH5401 Tool/software: Hello,
The datasheet SE-Diff THD is given for G=4V/V, 200Ohm total feedback resistance, Vs=5V & Vo=2Vpp.
For the same conditions, but G=3V/V should I expect a distortion change like delta THD>=6dB.
For the same…
Part Number: LMH5401 Tool/software: I would assume the quoted slew rate for the LMH5401 (17,500 v/us) is measured differentially across both outputs, the figure would halve when using only one of the outputs. Is this assumption correct?
Part Number: LMH5401 Tool/software: Hi,
the datasheet does not give any numbers for the input resistance of the CM pin.
It only states that it is "very high".
Do you know the minimum resistance for this pin?
I have to make sure that it can…
Part Number: LMH5401 Tool/software: Hello,
Figure 23 of the LMH5401 datasheet shows the input-referred voltage noise up to a frequency of 10MHz. How do I determine the input-referred voltage noise at frequencies higher than 10MHz?
-Ben
Part Number: LMH5401 Tool/software: My requirement is to amplify a current signal with a frequency between 1MHz-600MHz, and simulate it using the following network in TI TINA.
The AC transmission curve has a small difference within 600MHz, which meets…
Part Number: LMH5401 Tool/software: Hi team,
My customer is planning to carry out SI analysis to ensure the quality of high-speed signals such as those in the GHz band.
I understand that there are no IBIS models for analog signal products, including…
Part Number: LMH5401 Tool/software: Hello TI Team,
We are currently working on a hardware design involving the LMH5401-SP, and we would like to simulate its integration with other elements.
Could you please provide the S-parameter models for this…
Part Number: LMH5401 Tool/software: Hi team
For the LMH5401, there is recommended resistor setup as below in the datasheet:
Since customer want to both cover 2V/V gain and 3.5V Gain, they want to choose the resistor value as below for 2V/V. If this…
