Search tips
Showing 9 results View by: Thread Post Sort by
    Answered

  • LMH6714 with +/-4.5V Rails

    Resolved
    Other Parts Discussed in Thread: LMH6714 , LMH6514 Hello, I'm planning to use the LMH6714 with voltage rails of +/- 4.5V. How will device performance be impacted by reducing these rails from the +/-5V that is specificied in the EC table. Specifically…
    • Resolved
    • Answered

  • Error with LMH6714 PSPICE Model in TINA-TI

    Resolved
    Other Parts Discussed in Thread: LMH6714 , TINA-TI Hi, Now I'm trying to simulate with LMH6714 PSPICE model in TINA-TI but I'm facing error. And so I replaced LMH6714 model to normal OPAMP model then transient simulation was done with no error. Can you…
    • Resolved
    • Answered

  • LMH6505 and LMH6714 - internal delay time(latency)

    Resolved
    Other Parts Discussed in Thread: LMH6505 , LMH6714 , LMH6401 , LMH6517 Hi all, Would mind if we ask LMH6505 and LMH6714? <Q1> How long is the internal delay from input to output?(ns? us? it means latency with internal processing) The datasheet P2 shows Time…
    • Resolved
    • Answered

  • RE: LMH6505: AGC circuits at V+/V- = 7V/0V

    Resolved
    Sima, After considering LMH6714 and LMH6609 power supply spec, my customer would like to use the following power supplies. LMH6605 V+ = LMH6714 V+ = LMH6609 V+ = 8V. LMH6605 V- = LMH6714V- = LMH6609 V- = GND. Is this acceptable? Best regards, K.Hirano

  • need replacement for obsolete CLC404 that is available bare die form.

    Other Parts Discussed in Thread: LMH6714 I'm looking for an equivalent replacement for the obsolete CLC404, but must be available in bare die.
    • Answered

  • RE: LMH6572 & LMH6570 Spice model

    Resolved
    I do not see how I could use LMH6714 to replace LMH6572 as LMH6714 is an op amp, and LMH6572 is a mux

  • RE: SN74ACT240DW and LMH6714MF/NOPB Part Status

    The LMH6714 is still in full production. I am not sure on the logic series, I don't work with that product line.
    • Answered

  • RE: Video amplifier selection for DM814x and AM387x with integrated reconstruction filter.

    Resolved
    Are you looking for a video buffer? We have some LMH current feedback amplifiers that are good for high resolution video. The LH6714 family offers good performance. If you use a 1500 Ohm resistor on your CPU you can use the non inverting input of one…
    • Answered

  • Re: Bandwidth of current feedback amplifiers

    Resolved
    I'm one of the newly acquired National employees, so I'm going to refer you to a part that I worked on years ago. The LMH6714 is a classic current feedback amplifier. If you look at the datasheet on page 9 figure 1 there is a chart that shows…

Didn't find what you are looking for? Post a new question.