Part Number: LMP8601-Q1 Other Parts Discussed in Thread: LMP8601 Tool/software: We are using LMP8601QMAX device.
It has been working fine during the validation testing for the past few weeks.
During the validation, suddenly the LMP8601 output goes…
Part Number: LMP8601-Q1 Tool/software: Hi,
I would like to know what impedance the OFFSET pin can seen from the external voltage source?
If you don't have an exact figure, it will also good if you share the maximum possible current that OFFSET pin…
Part Number: LMP8601 Other Parts Discussed in Thread: INA271 ,
Hello,
I'm using following circuit for bidirectional current monitoring using LMP8601-Q1.
I have some design requirements of measuring +/- 15V with maximum of 2A flowing through it.…
Part Number: LMP8601-Q1 Tool/software: Hi,
While testing the LMP8601x device it has been observed that IN+ and IN- pins are having a voltage of 2.5V when the current measurement inputs are left floating (i.e., without input condition).
The test setup…
Part Number: LMP8601-Q1 Other Parts Discussed in Thread: LMP8601 , LMP8602-Q1 , INA185 , LMP8602 We are monitoring the current through a Shunt resistance of 40mOhm through LMP8601-Q1 with an GAIN configuration of ~50V/V.
For the diagnostic purpose,…
Part Number: LMP8601-Q1 Other Parts Discussed in Thread: LMP8601 , INA240-Q1 Hi, I have questions regarding LMP8601-Q1
1) What does this value "midscale offset scaling accuracy" stand for? What does it mean?
2) What is the meaning of the absolute…
Part Number: LMP8601 Hi team,
I downloaded the PSpice model for the LMP8601 and the pinout does not match the datasheet. Below is what I'm seeing in PSpice (left) and the datasheet (right). I annotated a snip w/ what I assume are the correct DS pin…
Part Number: LMP8601 Hi guys,
I`m not sure if I understand it correctly. Max. Voltage on V+, V- is -22V...60V (to GND).
But what is the max. differential voltage between the pins V+ and V-??? I guess I cant supply -22V on one pin and +60V on the…
Part Number: LMP8601 Hello,
I'm using following circuit for bidirectional current monitoring using LMP8601MA.
With these values, I'm wondering to obtain a Gr = 7.654 and output offset of Vs/2.
Input current range is +/-20mA, I used 10Ohm shunt…
Part Number: LMP8601-Q1 Other Parts Discussed in Thread: LMP8601 , INA240 Dear All
I need to sense current in a high side switched inductive load. To protect IC +IN and -IN inputs from going negative at switch off beyond the specified voltage can…
