Part Number: TPS653852A-Q1 Hi Expert,
My customer is a manufacture for Auto EPS who uses our TPS653852-Q1. After checking with other similar posts on E2E , I still has some questions that need your kindly guidance.
Does adding a 10k-ohm resistor…
Part Number: LM5113-Q1 Other Parts Discussed in Thread: LMG1205 , LMG1210 , Right now, we are developing the new controller. We are looking for single GAN FET for replacement of back-to-back N-channel MOSFET. The back-to-back N-channel MOSFETs are used…
Part Number: LM4040-N-Q1 Tool/software: We are currently utilizing the component 'LM4040DIM3X-5.0/NOPB' in our project.
Could you please provide the estimated number of years remaining until end-of-manufacturing for the component (an approximate estimate…
Part Number: AM62P-Q1 Other Parts Discussed in Thread: AM62P Hi experts:
In order to optimize layout, out customer want to swap LVDS output P&N signal. But at TRM OLDI data pin IO configuration we do not find the polarity swap setting.
So we think…
Part Number: TPS6594-Q1
Tool/software:
Hi,
We found <redacted part number> on some reference design, but can't found this full part nubmer on TPS6594-Q1 datasheet.
1. May I know is there have datasheet for <part number?? Is it need NDA?
2. The…
Part Number: LM74722-Q1 Hi team,
Is the operating current while keeping the N-ch FET ON 27uA? I'm confused because there is I_cap value in the several mA, and would appreciate if you could explain it to me. What customer wants to know is how much lower…
Part Number: LMV324-N-Q1 Tool/software: I was introduced by the TI support center team to have specifc answer for below questions for the art number LMV324Q1MTX.
After we receives this device from TI,
How long we can store this part in our warehouse…
Part Number: CDC6C-Q1 Tool/software: Hi team,
My customer asked what’s 25MHz CDC6Cx-Q1 orderable P/N for DS90UB971RHBTQ1? Thanks
Best Regards
Xiaowei Zhang
Part Number: LMV321-N-Q1 Other Parts Discussed in Thread: LMV321 , LMV321A Tool/software: Good evening,
I'm trying to simulate a buffer circuit with an LMV321 in PSpice for TI (see first picture), theoretically I shouldn't be respecting the common mode…