Part Number: MSP430FR4133 Other Parts Discussed in Thread: MSP430FR6877 Greetings,
I am attempting to establish communication between the MSP430FR4133 and MSP430FR6877 MCUs using UART. The MSP430FR4133 uses a 32.768 KHz external crystal for its operation…
Part Number: MSP430FR4133 Other Parts Discussed in Thread: MSP430G2553 Im trying to map code from an existing library I found so that I can drive a ws2812b LED strip. I found the library here https://github.com/mjmeli/MSP430-NeoPixel-WS2812-Library . Ive…
Part Number: MSP430FR4133 Hello.
We are moving from PIC micro to TI-MSP430 micro in our company.
I got a launchpad and install CCS V12.2 and start playing around.
From here I may not use the right terminology, so excuse me for that.
I realized that the…
Part Number: MSP430FR4133 Hello I am using the msp430fr4133 mcu.
If the system is short while using the fram memory, the specific memory area is initialized(or erase?) to 0xff.
The strange thing os that there is no chance of overwriting in the area because…
Part Number: MSP430FR4133 I was able to flash MSP430 using MS VScode with the following code
e2e.ti.com/.../ccs-msp430fr6972-msp430fr69xx-jtag-password
but when I try using CCS to flash the Out of Box stuff, I get the JTAG password error???
Part Number: MSP430FR4133 I got some issues about msp430 code, I connected infrared sensor with p1.0, so I just identify whether p1.0 is high or low level, then let p1.7 generate different duty cycle PWM i.e. 7.5% at high level and 13% at low level.
but…
I've confirmed that the information FRAM contains all 0xff in a sample of MSP430FR4133 chips fresh from the factory.
It would be nice if this was specified somewhere so we could depend on this condition.
Part Number: MSP430FR4133 From the MSP430FR4133 datasheet:
...but when I set this bit and disable an external XTAL then I see power usage go up by ~20uA, which suggests that the chip is, in fact, failing over to the REFO clock.
Is the XT1FAULTOFF bit…
Part Number: MSP430FR4133 I am trying to write C software to programme the MSP430 so that I can create a data signal for the WS2812b LED strip. The data pulses are required to have an amplitude in the range of 3.7 V to 5.3 V. Since im using a GPIO pin…