Part Number: MSPM0G1107 Other Parts Discussed in Thread: ADS131M04
Tool/software:
We are designed with MSPM0 based processor for one of digital signal processing application. We are collected 512 sampled of 16-bit ADC data through ADS131M04 sampling…
Part Number: MSPM0G1107 Other Parts Discussed in Thread: SYSCONFIG Tool/software: Hi team,
Customer would like to use internal crystal (32MHz) in order to save GPIO. They have some concern about below items. Please help clarify. Thank you.
1. In Sysconfig…
Part Number: MSPM0G1107 Tool/software: I have an equipment fixture to program 8 board assemblies at the same time.
If I program all 8 the programmer works fine.
If I try to program less than 8 board assemblies, all positions fail with the n=message…
Part Number: MSPM0G1107 Other Parts Discussed in Thread: SYSCONFIG Tool/software: Hello, I am moving from another uC to this family @ our company for new products (currently NXP)... Right now, I am trying to look around and get all the information about…
Part Number: MSPM0G1107 Other Parts Discussed in Thread: MSPM0-SDK Tool/software: I need better documentation of base register locations. I am looking at MSPM0 G-Series 80MHz Microcontrollers Technical Reference Manual and the MSPM0G110x Mixed-Signal…
Part Number: MSPM0G1107 Tool/software: Hi，
The project uses the MSPM0G1107 chip and is about to enter the mass production stage. Currently, it is being burned-in using a TI EVM, but this method of burn-in is too inefficient. Is there any other recommended…
Part Number: MSPM0G1107 Other Parts Discussed in Thread: CCSTUDIO Hi ti team,
The customer uses CCSTUDIO to compile MSPM0G1107, and I only support M0 series products when I see CCStudio-THEIA on the official website. Please check if you can use CCSTUDIO…
Part Number: MSPM0G1107 Other Parts Discussed in Thread: MSPM0L1117 , LP-MSPM0G3507 Tool/software: Dear Support Team, I have a question regarding above ERRATA ADC_ERR_06. We have several customer Boards, power supply of controller is 3.0V Analog Reference…
Part Number: MSPM0G1107 Tool/software: Is it possible to use SWO for Debug Logs / Tracing on the MSPM0G1107TPTR? If yes which Pins are ment to be used?
XDS110 Debug Probe is used
Part Number: MSPM0G1107 Other Parts Discussed in Thread: ADS114S08B ,
Tool/software:
Hello,
I'm considering handling GPI (interrupt) via a pin shared with the MISO on the SPI bus. Actual use case is to read "Data Ready" signal from the ADC (ADS114S08B…
