Part Number: MSPM0G1507
Hi Team,
What value pull up resistors need to be populated for SWD and SWCLK (JTAG)
Our design has 10K and 3.33K resistor used in many places.
In data sheet a 47K pullup resistor for reset is mentioned along with 10nF cap.
…
Part Number: MSPM0G1507 Hello,
I try to suppose to calculate Min sampling time based on equations in 7.12.4 Typical Connection Diagram in the data sheet of MSPM0G1507 but Settling error is not defined. What is Settling error?
Best regards, DDdoor
Hi
Here is our design & system team answer.
1.Are these typical values or worst case? These are worst case values. Worst Case is observed at Temp=130degC, LOT(Process)=HOTCOLD. 2. Is this data true for both G and L series? This data is collected for…
Part Number: MSPM0G1507 Other Parts Discussed in Thread: LP-MSPM0G3507
Dear MSPM0 champs,
The questions are here related to ADC acquisition with DMA use : A small MSPM0 project has been set up (derived from driver lib examples) where the ADC is used…
Part Number: MSPM0G1507 Using routines, I can write to flash normally, but I cannot read FLASH data. What function is used to read data? Using Flashctl_ Multiple_ Size_ Read_ Verify, cannot read data, can only verify API reading, no specific data.
Part Number: MSPM0G1507 hi, please let me know, where could I find the RGE package info. The datasheet for M0G1507 doesn't have the drawing and it is not documented here: https://www.ti.com/packaging/docs/searchtipackages.tsp?packageName=QFN
regards…
Part Number: MSPM0G1507 Hello,
Customer would like to use adviceLUNA II to debug MSPM0G1307. Is there any concerns on adviceLUNA II? Any advices would be very appreciated.
Regards,
Part Number: MSPM0G1507 Our system uses TIMA PWM outputs to drive the gates on high current FETs and it would be helpful to force these PWMs low whenever the CPU hits a breakpoint on the debugger. Does such a feature exist for TIMA PWMs? I only see the…
Part Number: MSPM0G1507 Does TI have any recommendations for PCB finishes (HASIL, ENIG, etc.) to use with the 32-pin VQFN package? Are the recommendations in this appnote applicable to the MSPM0 VQFN package?