Part Number: OPA2356 Hello team,
I am looking for a replacement for OPA2356AIDGKR, could you assist me here?
Drop in is preferred if not possible, then please p2p.
Thank you.
Kind regards,
Wouter Kragt
Part Number: OPA2356 In the Packaging Information chapter of the data sheet of the part OPA2356 a variant OPA2356AIDGKT.B is listed with an extended temperature range. This type is not mentioned in the Electrical Characteristics section. Are there plans…
Part Number: OPA2356 Good day,
I am with HDL Research Lab, Inc in Brenham, Texas. We are currently experiencing a failure with an OPA2356AIDR in one of our designs. I have attached the failure report below. We are looking to figure out how this failure…
Part Number: TIDA-01187 Other Parts Discussed in Thread: OPA2356 , THS4541 , OPA857 , TLV3601
Tool/software:
This question is releated to
TIDA-01187: Schemati Review of TIDA-01187 based design, using THS4541 as single ended output
I exactly used…
Part Number: OPA2356-EP I have designed a circuit using the OPA2356-EP, with 100nF decoupling capacitance as suggested in power supply recommendations on page 19 of the datasheet. However I notice that page 20 lists 10uF as the minimum decoupling capacitance…
Part Number: OPA2356 Other Parts Discussed in Thread: TLV3502 Tool/software: Hi,
I am planning to use the OP AMP with Mfr No: OPA2356MDGKTEP for an overcurrent sensing application at 400 kHz.
For this, I would like to know the propagation delay of…
Part Number: OPA2356 Other Parts Discussed in Thread: OPA356 Hello team,
Is there any simulation model for OPA2356? I could not find it on TI.com.
The simulation model for pspice or TINA is preferred, but any simulation model is welcome.
Best Regards…
Part Number: OPA2356 Dear TI Team
Our customer is considering OPA2356AIDR. Would you please teach me the impedance of the input terminals (No.2,3,5,6) of OPA2356?
Best Regards,
Y.Ottey
Part Number: OPA2356 The datasheet contains a note stating that Continuous currents above 60mA are not recommended. This implies parameters in the table of electrical characteristics with currents greater than 60mA should only be observed with pulsed…
Other Parts Discussed in Thread: OPA2356 , OPA2355 , OPA355 , OPA356 , TINA-TI Hello, can anyone tell me the different betwen OPA2356 and the OPA2355?
I can only see that the OPA2356 have no enable.
It is importent, because I want to simulate my circuit…
