Ryan,
Please use the document below (custom connections), when deciding how to make connections between the USB-DAQ-Platform and your module (slides 10 & 11). Figure 6-3 is correct, but the document below shows the specific EVM connections needed…
Part Number: PGA308EVM Tool/software: I do not find a jumper table in any of the pga308evm documentation on how to set up the test board to program an external stand alone packaged sensor .
What jumpers must be set and what position as well as what terminals…
Part Number: PGA308EVM Other Parts Discussed in Thread: PGA308 , Tool/software: I'm attempting to follow the flow chart in Figure 5-14 of the user manual.
I'm using an Arduino Uno to drive & a logic analyzer on vout_F to verify steps.
The register…
Part Number: PGA308EVM Other Parts Discussed in Thread: PGA308 , Hello,
One customer need to modify the registers in OTP of PGA308, but he found that he couldn't edit it when click the mouse, for example, how to change the CFG2 registers , he tried…
Part Number: PGA308EVM Other Parts Discussed in Thread: PGA308 , Hi Team,
Please
My custom circuit with PGA308 is shown below.R2 is removed for real circuit.
And we try to calibrate this external sensors follow the connection below:
For the calibration…
Part Number: PGA308EVM Other Parts Discussed in Thread: PGA308 Hello,
Need assistance for calibration process of an external sensor with external power supply.
Struggling to get output voltage on external meter.
Please give me a call to go through jumper…
Part Number: PGA308EVM Other Parts Discussed in Thread: PGA308 , Hello,
I bought a PGA308 eval board from you, it won't recognize the USB on my laptop.
I have gone through checking JUMP4 and JUMP5 (in the "Address Select" section) and everything seems…
Part Number: PGA308EVM Hi there, I am currently using the PGA308EVM and am trying to test several gain values but am running into a problem where the Set Vin value is not being read properly by the software and USB DAQ. For example, I have Auto Vin Vdif…
Hey Milos,
In that case, I recommend going with the PGA308, I do not believe you will have to adjust your bridge excitation, it can stay at 5V. The PGA308 has an output clamp meant to interface with ADCs as needed, here are a couple of options of how…
Part Number: PGA308EVM Tool/software: TI C/C++ Compiler Hello we bought PGA308EVM board. And Windows 10 driver issue. Windows 10 shows usb unknown device.
i research forum and i found this link: https://e2e.ti.com/support/amplifiers/f/14/t/752778
Same…