Part Number: SN74LVC1G10 Tool/software: Dear Technical Support Team,
I am desgnin a reset circuit for my microcontroller with your product SN74LVC1G10DCKR.
What I am intending to do is, when the three buttons pressed in the device, a reset is performed…
Part Number: SN74LVC1G10 Tool/software: Does the LVC chip require a resistor to Vcc +3.3V ? or can it be connected directly if not connected to another source ?
Part Number: SN74LVC1G10 I am using this device and encountered a very strange situation.
Static part of operation: Pin A,B have 5 Volt positive input, VCC is 5V.
Pin C has a 133K ohm resistor (Rc) to ground, no capacitors. I apply 5V to Pin C get…
Part Number: SN74LVC1G10 Hi,
Can i please know the difference between SN74LVC1G10DCKR and SN74LVC1G10DCKRG4.
Although G4 suffix means green, but according to the datasheet both the part numbers are green. Can you please help regarding this query.…
Other Parts Discussed in Thread: SN74LVC1G10 Hello!
I have a short question:
I have recieved a device that I am told is the SN74LVC1G10, but the marking on it does not seem to match the marking that the datasheet specifies. Is "TU3KE" a valid device…
Part Number: SN74LVC1G00 Other Parts Discussed in Thread: LM339 , SN74LVC00A , SN74HCS00 , SN74LVC1G10 Hello,
hoping to get some input on my design,
I want to latch some LM339 comparator output (active low) for overcurrent and ground fault, and i…
Hi Micheal,
the Data rate ranges from DC to 20MHz.
By the way, the LVCMOS output driving the SN65LVDS20's A input will be a SN74LVC1G10 from TI. :-)
Regards, Niels
OK,
But I used AMC1301 because that I follow TI design SPEC "Reference Design for Reinforced Isolation Three-Phase Inverter With Current, Voltage, and Temp Protection"
ti isolation design.pdf
