Part Number: TIDA-010003 Other Parts Discussed in Thread: CC1310 , , TIDA-010032
Hi,
I want to setup a 6LoWPAN mesh network with DTLS and CoAP with CC1310 sensor nodes.
TIDA-010003 gives me a great starting point with 6LoWPAN and TI-15.4.
As data…
Part Number: LAUNCHXL-CC1312R1 Other Parts Discussed in Thread: TIDA-010032 , Tool/software: Code Composer Studio Hi to all,
I'm using LAUNCHXL-CC1312R1 with library version (2.40, TIDA-010032).
In the UART write part I'm not able to write more than…
Part Number: TIDA-010024 Other Parts Discussed in Thread: TIDA-010032 Tool/software: Code Composer Studio Sir,
I want to create a 4 Node Liner Hop topology.
For DCU/Data Collector or concentrator I'm using TIDA-010032 and For node side, I'm using…
Hello nilesh,
We have two of them. If you prefer an embedded based one, look at this: http://www.ti.com/tool/TIDA-01547
If you prefer a linux based one, look at this: http://www.ti.com/tool/TIDA-010032
Regards,
AB
Mateo,
Sorry, this reference design is obsolete and not supported. Please refer to replacement design at
http://www.ti.com/tool/TIDA-010032
Regards
amrit
Hi Ikon,
I would recommend that you take a look at these two reference designs for CC1312R:
www.ti.com/.../TIDA-010032
www.ti.com/.../TIDA-010024
Regards,
Fredrik
Hi Shilpa,
No. The TI design of TIDA-010003 (with CC1310) supports the end-node configuration only. If you want to do a network demo with the design, you will need to have a master set-up with MSP432 LP (TIDA-01547), CC1312 LP (TIDA-010024) or AM3358…
Part Number: CC1312R Other Parts Discussed in Thread: TIDA-010024 , , TIDA-010032
Tool/software: TI-RTOS
Hello TI,
We are using debug_poll and debug_root_poll applications to test mesh networking with our customised cc1312 board, we could able to…
Hi Janusz,
The DEBUG_FULL macro was implemented/verified with TIDA-010032 (based on Linux) only. To debug the TIDA-10003 or TIDA-01547, I would recommend to run CCS debug mode by adding some variables to watch. You can check Section 3.1.2.2.3.1 in…
