Part Number: TLV07 Hello,
I have a batch of TLV07IDR arrived recently.
But the lead frame is different from my history record.
Could you please check and advise if this is a normal situation?
Thanks!
kai klaas69 said: A faster method is to let the OPAmp charge the sampling capacitor by its high speed and fast settling time. Then the charge bucket filter can look much less heavy and its only duty is to support the charge transfer. The charge bucket…
Part Number: TLV07 I am trying to simulate frequency response of TLV07 in non-inverting configuration for gain 10 as shown below:
The frequency response shows peaking as shown below:
It is worse for smaller values of resistors like 1 and 10:
The…
Part Number: TLV07 Other Parts Discussed in Thread: OPA333 Customer would like to use TLV07 to sense the DC voltage of 38V~60V with the below circuits. Could you please help check whether there any any concerns? Thank you.
Part Number: TLV07 Other Parts Discussed in Thread: OPA196 Are there plans to put TLV07 in a smaller package? Seems like it is only available in SOIC-8 at the moment.
Thanks!
-Steve
Part Number: TLV07 Hello,
I am looking for advice in protecting the input pins on TLV07 op amp. My design is intended to measure input signals from 0-20V and I've extended the power rails to -4V and +24V to ensure linearity throughout the measurement…
Part Number: TLV07 Other Parts Discussed in Thread: TINA-TI
Hi,
I've made some experimentation with TINA-TI and TLV07 model. TLV07 was powered as single-supply 0V to +15V.
According to the TLV07's datasheet, the output voltage swing limitation of…
Part Number: TLV07 Other Parts Discussed in Thread: OP07 , TL074
Hi,
one of my customer is testing TLV07 to measure the DC bus current in their solar inverter system.
The schematic is as below, the shunt resistor is at the GND side, so the common mode…