Part Number: TLV07 Other Parts Discussed in Thread: TINA-TI
Hi,
I've made some experimentation with TINA-TI and TLV07 model. TLV07 was powered as single-supply 0V to +15V.
According to the TLV07's datasheet, the output voltage swing limitation of…
Part Number: OP07C Other Parts Discussed in Thread: TLV07 , OPA202 Hi,
Do you have the OP07C "Temperature vs. Current Consumption" Data? The customer is considering a replacement from NJMOP-07.
We also introduce TLV07, which has this data in the…
Marek,
I've done experiment with the customer today.
We found that the abnormal happens when pin2 or pin3 of TLV07 is touched by the probe of scope or multimeter.
When pin2 is touched, the boost stage will stop working and the current sensed will…
Part Number: TLV07 Other Parts Discussed in Thread: OP07 , TL074
Hi,
one of my customer is testing TLV07 to measure the DC bus current in their solar inverter system.
The schematic is as below, the shunt resistor is at the GND side, so the common mode…
Part Number: LM321 Other Parts Discussed in Thread: TLV07 , OPA189 , OPA991 Hi there,
In the datasheet of LM321, the input offset voltage is 2mV typically. Does it mean +IN needs to be 2mV higher than -IN? Or it is possible that -IN needs 2mV higher than…
Hi Shreeneet,
TLV07 is not low voltage precision op amp. It has Vcm limitation for the 3.3Vdc supply rail.
TLV E2E 07022023.TSC
It may work if the resistor is lower to <= 65Ω range. Here is the alternative with LPF filter
TLV AC response 07222023…
Hi Cherry,
Cherry Zhou said: In general, signal attenuation between 2Hz and 5000Hz must be guaranteed to be less than 0.5%. Could you help share some learning documents on filtering for reference?
Would this one work for the customer? We can adjust the…
Other Parts Discussed in Thread: TLV9062 , TLV9002 , TLV07 , INA351 , INA199 , INA181 , TLV333 Hello Community,
We are working on a highly cost-sensitive Data Acquisition system and seeking your valuable expertise to guide me through the design process. The…
Hi Jungsoo,
in this case the capacitance of decoupling cap is rather uncritical.
You might also want to read this thread, where we have discussed the advantage of having a charge bucket filter at the input of ADC:
https://e2e.ti.com/support/amplifiers…
Your App does not seem to require RRinput, if not
Perhaps look at the TLV07
If it does,
Look at the TLV197-Q1 (not sure if there is a non Q1 version, but if so, look at that).
These are singles, if multichannel is more useful - those are out there as…